OWC 8GB DDR4 3200MHz CL22 1.2V 288-pin UDIMM memory upgrade
- 8GB
- 288-Pin DDR4 Non-EC…
Akceptujemy kryptowaluty — posiadane środki można więc wykorzystać na zakup prawdziwego sprzętu.Płatność kryptowalutą — realny sprzęt w zamian. Bezpłatna, ubezpieczona dostawa na całym świecie powyżej 399 $. Neutralne kartony, bez oznaczeń, wysyłane z Niemiec.Bezpłatna, ubezpieczona dostawa powyżej 399 $. Kurs zostaje zablokowany na 30 minut od otwarcia kasy.Kurs zablokowany na 30 minut. Każdy produkt jest fabrycznie zapieczętowany, jego numer seryjny jest sprawdzany, a całość objęta jest 24-miesięczną gwarancją.Zapieczętowane fabrycznie, 24 miesiące gwarancji.
OWC
8GB DDR4 2666 ECC UDIMM with CL19 latency and 1.2V operation, validated for QNAP TS-h1283XU-RP, TS-h1683XU-RP, TS-h2483XU-RP, TS-h686 and TS-h886 NAS systems
This 8GB DDR4 2666 CL19 ECC unbuffered module is built for QNAP TS-h1283XU-RP, TS-h1683XU-RP, TS-h2483XU-RP, TS-h686 and TS-h886 systems. It adds capacity while maintaining data integrity through error-correcting code. The single-rank 1Rx8 design fits standard 288-pin DIMM slots. It replaces QNAP part number RAM-8GDR4ECT0-UD-2666 directly.
The module operates at 1.2 volts and meets JEDEC PC4-21300 specifications for broad compatibility. It is backward compatible with 2133MHz and 2400MHz bus speeds. The bare circuit board allows installation in tight NAS chassis where tall heat spreaders would block adjacent slots or airflow. No extra power connectors or tools are required for the upgrade.
Confirm the exact model number matches the supported list above. Check how many memory slots your unit has populated and the maximum capacity per slot allowed by the firmware. Ensure the system accepts unbuffered ECC UDIMMs rather than registered or load-reduced variants. This module is not suitable for platforms that require registered memory or non-ECC consumer DIMMs.
| Brand | OWC |
|---|---|
| Part Number | 2E6D41R808GB |
| Capacity | 8GB |
| Type | 288-Pin DDR4 ECC UDIMM |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | CL19 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Rank | 1Rx8 |
| Heat Spreader | No |
| Compatible System | QNAP TS-h1283XU-RP QNAP TS-h1683XU-RP QNAP TS-h2483XU-RP QNAP TS-h686 QNAP TS-h886 |
Inne wersje tego modelu
Ta sama rodzina, inna pamięć, inne chłodzenie lub taktowanie — proszę porównać przed decyzją.
The module is rated for 2666 MHz PC4-21300 CL19 at 1.2 V; the listed QNAP models accept this speed natively, so it will operate at the full 2666 MHz data rate.
Yes, the stick uses the standard 288-pin UDIMM form factor with no heat spreader, matching the slot keying and height clearance of the TS-h686 and TS-h886 NAS units.
Power off the NAS, open the chassis, align the notch on the 288-pin edge connector with the slot key, press firmly until both retention clips click, then power on and verify 8 GB in the system information.
Także w tym dziale
Ten sam dział, ta sama kasa — osiem kryptowalut i 30-minutowa blokada kursu.
Waluta płatności i waluta wyświetlania cen.
Wysyłane z portfela przy kasie
Tylko podgląd — katalog wyceniony jest w dolarach
Brak pasującej waluty.
Wybierz język, w którym wyświetla się strona.
Pierwsza wizyta?
Konto już założone?
Nie ma automatycznego resetowania hasła: ten sklep nie wysyła żadnych e-maili, więc nie ma jednorazowego linku, o który można by poprosić. Adres pozostawiony przy koncie zostanie obsłużony ręcznie.
Zgłoszenie zapisane
Do skrzynki odbiorczej nic nie trafi — ten sklep nie wysyła żadnych e-maili. Zgłoszenia są obsługiwane ręcznie.
Hasło się przypomniało?