Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties

HP

HP 4 TB 7.2K 3.5" SATA MDL SC Gen8 693687-B21 internal hard drive

SKU CH-2E8N-ERA7T

Stores 4 TB of data on a 3.5" SATA drive spinning at 7.2K rpm for Gen8 servers

  • 4 TB capacity stores large media libraries
  • 2 K rpm spindle delivers responsive throughput
  • SATA 6 Gb/s interface fits standard desktop ports
  • 5-inch form factor mounts in typical drive bays
  • New condition ensures full manufacturer specification

HP 4 TB SATA 3.5" Hard Drive

This HP 4 TB hard drive uses a SATA interface and a 3.5 inch form factor. It spins at 7.2 K RPM and is designed for desktop internal storage. The model carries part numbers 693687-B21 and 693720-001.

Suits desktop builds needing bulk capacity

Buyers who need faster access times or a smaller 2.5 inch form factor should look elsewhere. This drive is not intended for laptop bays or high-performance caching roles.

Standard SATA installation in 3.5" bay

Connect the drive using SATA data and power cables, then secure it with four screws in a 3.5 inch bay. The most common issue is forgetting to initialise the disk in the operating system before use.

Priekšrocības

  • 4 TB capacity stores large media libraries
  • 2 K rpm spindle delivers responsive throughput
  • SATA 6 Gb/s interface fits standard desktop ports
  • 5-inch form factor mounts in typical drive bays
  • New condition ensures full manufacturer specification

Specifikācijas

Šai precei pagaidām nav publicētu specifikāciju.

Jautājumi par šo preci

Does my system need a 3.5-inch drive bay and a SATA power connector to install this HP 4 TB drive?

Yes, the drive uses a standard 3.5-inch form factor and requires both a SATA data cable and a SATA power connector from the host system.

Can this 7.2K RPM SATA drive share a controller with older 3 Gb/s SATA hard drives?

The drive is compatible with 6 Gb/s SATA and will negotiate down to 3 Gb/s speeds when connected to an older controller or port.

How can I confirm the drive is recognised at its full 4 TB capacity after installation?

Check the BIOS or operating system disk utility; it should report approximately 4 TB of available space for the model 693687-B21.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.