Wij accepteren cryptovaluta — zo kunnen de munten die u bezit echte hardware kopen.Betaal in crypto, besteed het aan echte hardware. Gratis verzekerde verzending wereldwijd vanaf $399. Neutrale dozen zonder merk, verzonden vanuit Duitsland.Gratis verzekerde verzending vanaf $399. Uw koers wordt 30 minuten vastgezet zodra het afrekenen begint.Koers 30 minuten vastgezet. Elk artikel is verzegeld, het serienummer wordt gecontroleerd, en het valt onder 24 maanden garantie.Verzegeld, 24 maanden garantie.

Favoriete artikelen Inloggen

HP

HP 4 TB 7.2K 3.5" SATA MDL SC Gen8 693687-B21 internal hard drive

SKU CH-2E8N-ERA7T

Stores 4 TB of data on a 3.5" SATA drive spinning at 7.2K rpm for Gen8 servers

  • 4 TB capacity stores large media libraries
  • 2 K rpm spindle delivers responsive throughput
  • SATA 6 Gb/s interface fits standard desktop ports
  • 5-inch form factor mounts in typical drive bays
  • New condition ensures full manufacturer specification

HP 4 TB SATA 3.5" Hard Drive

This HP 4 TB hard drive uses a SATA interface and a 3.5 inch form factor. It spins at 7.2 K RPM and is designed for desktop internal storage. The model carries part numbers 693687-B21 and 693720-001.

Suits desktop builds needing bulk capacity

Buyers who need faster access times or a smaller 2.5 inch form factor should look elsewhere. This drive is not intended for laptop bays or high-performance caching roles.

Standard SATA installation in 3.5" bay

Connect the drive using SATA data and power cables, then secure it with four screws in a 3.5 inch bay. The most common issue is forgetting to initialise the disk in the operating system before use.

Pluspunten

  • 4 TB capacity stores large media libraries
  • 2 K rpm spindle delivers responsive throughput
  • SATA 6 Gb/s interface fits standard desktop ports
  • 5-inch form factor mounts in typical drive bays
  • New condition ensures full manufacturer specification

Specificaties

Voor dit artikel zijn nog geen specificaties gepubliceerd.

Vragen over dit artikel

Does my system need a 3.5-inch drive bay and a SATA power connector to install this HP 4 TB drive?

Yes, the drive uses a standard 3.5-inch form factor and requires both a SATA data cable and a SATA power connector from the host system.

Can this 7.2K RPM SATA drive share a controller with older 3 Gb/s SATA hard drives?

The drive is compatible with 6 Gb/s SATA and will negotiate down to 3 Gb/s speeds when connected to an older controller or port.

How can I confirm the drive is recognised at its full 4 TB capacity after installation?

Check the BIOS or operating system disk utility; it should report approximately 4 TB of available space for the model 693687-B21.

Ook in deze afdeling

Klanten vergeleken ook

Dezelfde afdeling, dezelfde kassa — acht munten en een koers die 30 minuten vaststaat.