Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.

Praćeni artikli Prijava
Silver 3.5 inch hard drive with green circuit board visible

HP

HP 4 TB 7.2K 3.5" SATA MDL SC Gen8 693687-B21 internal hard drive

SKU CH-2E8N-ERA7T

Stores 4 TB of data on a 3.5" SATA drive spinning at 7.2K rpm for Gen8 servers

  • 4 TB capacity stores large media libraries
  • 2 K rpm spindle delivers responsive throughput
  • SATA 6 Gb/s interface fits standard desktop ports
  • 5-inch form factor mounts in typical drive bays
  • New condition ensures full manufacturer specification

HP 4 TB SATA 3.5" Hard Drive

This HP 4 TB hard drive uses a SATA interface and a 3.5 inch form factor. It spins at 7.2 K RPM and is designed for desktop internal storage. The model carries part numbers 693687-B21 and 693720-001.

Suits desktop builds needing bulk capacity

Buyers who need faster access times or a smaller 2.5 inch form factor should look elsewhere. This drive is not intended for laptop bays or high-performance caching roles.

Standard SATA installation in 3.5" bay

Connect the drive using SATA data and power cables, then secure it with four screws in a 3.5 inch bay. The most common issue is forgetting to initialise the disk in the operating system before use.

Istaknuto

  • 4 TB capacity stores large media libraries
  • 2 K rpm spindle delivers responsive throughput
  • SATA 6 Gb/s interface fits standard desktop ports
  • 5-inch form factor mounts in typical drive bays
  • New condition ensures full manufacturer specification

Specifikacije

Za ovaj artikl još nisu objavljene specifikacije.

Pitanja o ovom artiklu

Does my system need a 3.5-inch drive bay and a SATA power connector to install this HP 4 TB drive?

Yes, the drive uses a standard 3.5-inch form factor and requires both a SATA data cable and a SATA power connector from the host system.

Can this 7.2K RPM SATA drive share a controller with older 3 Gb/s SATA hard drives?

The drive is compatible with 6 Gb/s SATA and will negotiate down to 3 Gb/s speeds when connected to an older controller or port.

How can I confirm the drive is recognised at its full 4 TB capacity after installation?

Check the BIOS or operating system disk utility; it should report approximately 4 TB of available space for the model 693687-B21.

Također u ovoj kategoriji

Kupci su usporedili ovo

Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.