We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver 3.5 inch hard drive with green circuit board visible

HP

HP 4 TB 7.2K 3.5" SATA MDL SC Gen8 693687-B21 internal hard drive

SKU CH-2E8N-ERA7T

Stores 4 TB of data on a 3.5" SATA drive spinning at 7.2K rpm for Gen8 servers

  • 4 TB capacity stores large media libraries
  • 2 K rpm spindle delivers responsive throughput
  • SATA 6 Gb/s interface fits standard desktop ports
  • 5-inch form factor mounts in typical drive bays
  • New condition ensures full manufacturer specification

HP 4 TB SATA 3.5" Hard Drive

This HP 4 TB hard drive uses a SATA interface and a 3.5 inch form factor. It spins at 7.2 K RPM and is designed for desktop internal storage. The model carries part numbers 693687-B21 and 693720-001.

Suits desktop builds needing bulk capacity

Buyers who need faster access times or a smaller 2.5 inch form factor should look elsewhere. This drive is not intended for laptop bays or high-performance caching roles.

Standard SATA installation in 3.5" bay

Connect the drive using SATA data and power cables, then secure it with four screws in a 3.5 inch bay. The most common issue is forgetting to initialise the disk in the operating system before use.

Highlights

  • 4 TB capacity stores large media libraries
  • 2 K rpm spindle delivers responsive throughput
  • SATA 6 Gb/s interface fits standard desktop ports
  • 5-inch form factor mounts in typical drive bays
  • New condition ensures full manufacturer specification

Specifications

No published specifications for this item yet.

Questions about this item

Does my system need a 3.5-inch drive bay and a SATA power connector to install this HP 4 TB drive?

Yes, the drive uses a standard 3.5-inch form factor and requires both a SATA data cable and a SATA power connector from the host system.

Can this 7.2K RPM SATA drive share a controller with older 3 Gb/s SATA hard drives?

The drive is compatible with 6 Gb/s SATA and will negotiate down to 3 Gb/s speeds when connected to an older controller or port.

How can I confirm the drive is recognised at its full 4 TB capacity after installation?

Check the BIOS or operating system disk utility; it should report approximately 4 TB of available space for the model 693687-B21.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.