Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties
ATX power supply unit in metal casing with label showing voltage ratings

KHACHIMO

KHACHIMO WRA01X-C power supply +5V3A +12V0.5A -12V0.35A

SKU CH-GEHA-0WSG4

Delivers +5 V at 3 A, +12 V at 0.5 A and -12 V at 0.35 A for industrial medical equipment

  • TypeATX
  • Delivers +5 V at 3 A for reliable logic rail
  • Provides +12 V at 0.5 A to run auxiliary circuits
  • Supplies -12 V at 0.35 A for negative-rail needs
  • ATX form factor fits standard industrial and medical chassis

Industrial ATX Power Supply

The KHACHIMO WRA01X-C is an ATX form-factor unit built for industrial and medical equipment. It delivers regulated rails of +5V at 3A, +12V at 0.5A and -12V at 0.35A. Each unit is tested working before dispatch to confirm reliable operation in demanding environments.

Direct replacement for legacy ATX units

This supply fits existing ATX bays where the original unit has failed or drifted out of specification. The jump is worth it when equipment requires the specific +5V, +12V and -12V current ratings listed and a tested, good-quality replacement is needed to restore stable power.

Priekšrocības

  • Delivers +5 V at 3 A for reliable logic rail
  • Provides +12 V at 0.5 A to run auxiliary circuits
  • Supplies -12 V at 0.35 A for negative-rail needs
  • ATX form factor fits standard industrial and medical chassis

Specifikācijas

TypeATX

Jautājumi par šo preci

Does this ATX power supply fit a standard ATX case mounting pattern?

Yes, the WRA01X-C follows the ATX form factor so it mounts in any standard ATX chassis using the usual four screw holes.

What is the correct way to connect the -12 V rail and what mistake should I avoid?

Wire the -12 V 0.35 A output only to circuits that require a negative rail; connecting it to a ground or 0 V point will cause a short.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.