Vi tager imod kryptovaluta — så den krypto, du ejer, kan købe rigtig hardware.Betal med krypto, brug det på rigtig hardware. Gratis, forsikret levering til hele verden ved køb over 399 $. Neutrale, umærkede papkasser, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Din kurs låses i 30 minutter, så snart kassen åbner.Kurs låst i 30 minutter. Hver vare er forseglet, har kontrolleret serienummer og er dækket af 24 måneders garanti.Forseglet, 24 måneders garanti.

Prisvagt Log ind
ATX power supply unit in metal casing with label showing voltage ratings

KHACHIMO

KHACHIMO WRA01X-C power supply +5V3A +12V0.5A -12V0.35A

SKU CH-GEHA-0WSG4

Delivers +5 V at 3 A, +12 V at 0.5 A and -12 V at 0.35 A for industrial medical equipment

  • TypeATX
  • Delivers +5 V at 3 A for reliable logic rail
  • Provides +12 V at 0.5 A to run auxiliary circuits
  • Supplies -12 V at 0.35 A for negative-rail needs
  • ATX form factor fits standard industrial and medical chassis

Industrial ATX Power Supply

The KHACHIMO WRA01X-C is an ATX form-factor unit built for industrial and medical equipment. It delivers regulated rails of +5V at 3A, +12V at 0.5A and -12V at 0.35A. Each unit is tested working before dispatch to confirm reliable operation in demanding environments.

Direct replacement for legacy ATX units

This supply fits existing ATX bays where the original unit has failed or drifted out of specification. The jump is worth it when equipment requires the specific +5V, +12V and -12V current ratings listed and a tested, good-quality replacement is needed to restore stable power.

Fordele

  • Delivers +5 V at 3 A for reliable logic rail
  • Provides +12 V at 0.5 A to run auxiliary circuits
  • Supplies -12 V at 0.35 A for negative-rail needs
  • ATX form factor fits standard industrial and medical chassis

Specifikationer

TypeATX

Spørgsmål om denne vare

Does this ATX power supply fit a standard ATX case mounting pattern?

Yes, the WRA01X-C follows the ATX form factor so it mounts in any standard ATX chassis using the usual four screw holes.

What is the correct way to connect the -12 V rail and what mistake should I avoid?

Wire the -12 V 0.35 A output only to circuits that require a negative rail; connecting it to a ground or 0 V point will cause a short.

Også på denne hylde

Kunderne har også sammenlignet disse

Samme hylde, samme kasse — otte mønter og 30 minutters kurslås.