Kripto para kabul ediyoruz — böylece elinizdeki koinlerle gerçek donanım alabilirsiniz.Kripto parayla ödeyin, onu gerçek donanıma harcayın. $399 üzeri siparişlerde dünya genelinde sigortalı kargo ücretsizdir. Sade, markasız koliler Almanya’dan gönderilir.$399 üzeri siparişlerde sigortalı kargo ücretsizdir. Ödeme sayfası açıldığında kurunuz 30 dakika kilitli kalır.Kur 30 dakika kilitli. Her ürün mühürlüdür, seri numarası kontrol edilir ve 24 ay garanti kapsamındadır.Mühürlü, 24 ay garantili.

Favori ürünler Giriş yap
ATX power supply unit in metal casing with label showing voltage ratings

KHACHIMO

KHACHIMO WRA01X-C power supply +5V3A +12V0.5A -12V0.35A

SKU CH-GEHA-0WSG4

Delivers +5 V at 3 A, +12 V at 0.5 A and -12 V at 0.35 A for industrial medical equipment

  • TypeATX
  • Delivers +5 V at 3 A for reliable logic rail
  • Provides +12 V at 0.5 A to run auxiliary circuits
  • Supplies -12 V at 0.35 A for negative-rail needs
  • ATX form factor fits standard industrial and medical chassis

Industrial ATX Power Supply

The KHACHIMO WRA01X-C is an ATX form-factor unit built for industrial and medical equipment. It delivers regulated rails of +5V at 3A, +12V at 0.5A and -12V at 0.35A. Each unit is tested working before dispatch to confirm reliable operation in demanding environments.

Direct replacement for legacy ATX units

This supply fits existing ATX bays where the original unit has failed or drifted out of specification. The jump is worth it when equipment requires the specific +5V, +12V and -12V current ratings listed and a tested, good-quality replacement is needed to restore stable power.

Öne çıkanlar

  • Delivers +5 V at 3 A for reliable logic rail
  • Provides +12 V at 0.5 A to run auxiliary circuits
  • Supplies -12 V at 0.35 A for negative-rail needs
  • ATX form factor fits standard industrial and medical chassis

Teknik özellikler

TypeATX

Bu ürünle ilgili sorular

Does this ATX power supply fit a standard ATX case mounting pattern?

Yes, the WRA01X-C follows the ATX form factor so it mounts in any standard ATX chassis using the usual four screw holes.

What is the correct way to connect the -12 V rail and what mistake should I avoid?

Wire the -12 V 0.35 A output only to circuits that require a negative rail; connecting it to a ground or 0 V point will cause a short.

Bu reyondan diğerleri

Müşteriler bunları karşılaştırdı

Aynı raf, aynı sipariş tamamlama — sekiz koin ve 30 dakikalık kur kilidi.