Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.

Sledované položky Prihlásiť sa
ATX power supply unit in metal casing with label showing voltage ratings

KHACHIMO

KHACHIMO WRA01X-C power supply +5V3A +12V0.5A -12V0.35A

SKU CH-GEHA-0WSG4

Delivers +5 V at 3 A, +12 V at 0.5 A and -12 V at 0.35 A for industrial medical equipment

  • TypeATX
  • Delivers +5 V at 3 A for reliable logic rail
  • Provides +12 V at 0.5 A to run auxiliary circuits
  • Supplies -12 V at 0.35 A for negative-rail needs
  • ATX form factor fits standard industrial and medical chassis

Industrial ATX Power Supply

The KHACHIMO WRA01X-C is an ATX form-factor unit built for industrial and medical equipment. It delivers regulated rails of +5V at 3A, +12V at 0.5A and -12V at 0.35A. Each unit is tested working before dispatch to confirm reliable operation in demanding environments.

Direct replacement for legacy ATX units

This supply fits existing ATX bays where the original unit has failed or drifted out of specification. The jump is worth it when equipment requires the specific +5V, +12V and -12V current ratings listed and a tested, good-quality replacement is needed to restore stable power.

Prednosti

  • Delivers +5 V at 3 A for reliable logic rail
  • Provides +12 V at 0.5 A to run auxiliary circuits
  • Supplies -12 V at 0.35 A for negative-rail needs
  • ATX form factor fits standard industrial and medical chassis

Špecifikácie

TypeATX

Otázky k tomuto produktu

Does this ATX power supply fit a standard ATX case mounting pattern?

Yes, the WRA01X-C follows the ATX form factor so it mounts in any standard ATX chassis using the usual four screw holes.

What is the correct way to connect the -12 V rail and what mistake should I avoid?

Wire the -12 V 0.35 A output only to circuits that require a negative rail; connecting it to a ground or 0 V point will cause a short.

Aj v tomto oddelení

Zákazníci tiež porovnávali

Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.