NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.
OWC
8GB DDR4 3200 ECC registered RDIMM for server and workstation upgrades
This 8 GB DDR4 3200 module is built for workstations and servers that require registered ECC memory. It operates at PC4-25600 with a CL22 latency and runs at 1.2 V. The single-rank 1Rx8 design fits standard 288-pin RDIMM slots in compatible enterprise platforms.
The module follows JEDEC and RoHS standards without a heat spreader, keeping the profile low for dense server chassis. Registered buffering reduces electrical load on the memory controller, allowing larger total capacities in supported systems. ECC circuitry detects and corrects single-bit errors to protect data integrity.
This memory will not work in standard desktop computers or laptops that use unbuffered non-ECC DIMMs. It cannot be mixed with unbuffered modules in the same system. Check your motherboard or NAS documentation to confirm it accepts DDR4 3200 registered ECC RDIMMs before ordering.
| Brand | OWC |
|---|---|
| Part Number | 3R2D41R808GB |
| Capacity | 8GB |
| Type | 288-Pin DDR4 ECC RDIMM |
| Speed | DDR4 3200 (PC4 25600) |
| CAS Latency | CL22 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 1Rx8 |
| Heat Spreader | No |
The module runs at 3200 MT/s with CL22 timing; ECC and registered operation add one cycle of buffering, so sustained bandwidth is limited by the JEDEC PC4-25600 rating rather than raw frequency alone
It fits a standard 288-pin DDR4 DIMM socket; no heat spreader is present, so low-profile heatsinks or tight server chassis lids will not interfere with the bare PCB
Power down, open the retention clips, align the single key notch, press firmly until both clips snap shut, then verify in BIOS that ECC and registered modes are enabled — the missed step is confirming the memory mode after boot
Arī šajā sadaļā
Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.
Kriptovalūta, kurā maksājat, un valūta, kurā redzat cenas.
Nosūtīts no Jūsu maciņa, noformējot pasūtījumu
Tikai informatīvi — katalogā cenas norādītas ASV dolāros
Neviena valūta neatbilst.
Izvēlieties valodu, kurā vietne sarunājas ar Jums.
Pirmo reizi šeit?
Jau ir konts?
Automātiskas atiestatīšanas nav: šis veikals nesūta e-pastus, tāpēc nav arī vienreizējas saites, ko pieprasīt. Atstājiet adresi kontā, un tā tiks apstrādāta manuāli.
Pieprasījums saņemts
Uz Jūsu e-pastu nekas neatnāks — šis veikals vispār nesūta e-pastus. Kāds šos pieprasījumus apstrādā manuāli.
Atcerējāties?