NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.
OWC
8GB DDR4 3200 ECC registered RDIMM for server and workstation upgrades
This 8 GB DDR4 3200 module is built for workstations and servers that require registered ECC memory. It operates at PC4-25600 with a CL22 latency and runs at 1.2 V. The single-rank 1Rx8 design fits standard 288-pin RDIMM slots in compatible enterprise platforms.
The module follows JEDEC and RoHS standards without a heat spreader, keeping the profile low for dense server chassis. Registered buffering reduces electrical load on the memory controller, allowing larger total capacities in supported systems. ECC circuitry detects and corrects single-bit errors to protect data integrity.
This memory will not work in standard desktop computers or laptops that use unbuffered non-ECC DIMMs. It cannot be mixed with unbuffered modules in the same system. Check your motherboard or NAS documentation to confirm it accepts DDR4 3200 registered ECC RDIMMs before ordering.
| Brand | OWC |
|---|---|
| Part Number | 3R2D41R808GB |
| Capacity | 8GB |
| Type | 288-Pin DDR4 ECC RDIMM |
| Speed | DDR4 3200 (PC4 25600) |
| CAS Latency | CL22 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 1Rx8 |
| Heat Spreader | No |
The module runs at 3200 MT/s with CL22 timing; ECC and registered operation add one cycle of buffering, so sustained bandwidth is limited by the JEDEC PC4-25600 rating rather than raw frequency alone
It fits a standard 288-pin DDR4 DIMM socket; no heat spreader is present, so low-profile heatsinks or tight server chassis lids will not interfere with the bare PCB
Power down, open the retention clips, align the single key notch, press firmly until both clips snap shut, then verify in BIOS that ECC and registered modes are enabled — the missed step is confirming the memory mode after boot
Veel samast osakonnast
Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.
See, millega maksate, ja see, milles vaatate hindu.
Saadetud teie rahakotist kassas
Ainult kuvamiseks — kataloogi hinnad on dollarites
Ükski vääring ei vasta sellele.
Valige keel, milles sait teiega räägib.
Esimest korda siin?
Teil on juba konto?
Automaatset lähtestamist ei ole: see pood ei saada ühtegi e-kirja, seega pole ka ühekordset linki, mida küsida. Jätke aadress kontole alles, seda käsitletakse käsitsi.
Päring registreeritud
Teie postkasti ei jõua midagi — see pood ei saada e-kirju üldse. Keegi tegeleb sellega käsitsi.
Tuli meelde?