NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.
OWC
8GB DDR4 3200 ECC registered RDIMM for server and workstation upgrades
This 8 GB DDR4 3200 module is built for workstations and servers that require registered ECC memory. It operates at PC4-25600 with a CL22 latency and runs at 1.2 V. The single-rank 1Rx8 design fits standard 288-pin RDIMM slots in compatible enterprise platforms.
The module follows JEDEC and RoHS standards without a heat spreader, keeping the profile low for dense server chassis. Registered buffering reduces electrical load on the memory controller, allowing larger total capacities in supported systems. ECC circuitry detects and corrects single-bit errors to protect data integrity.
This memory will not work in standard desktop computers or laptops that use unbuffered non-ECC DIMMs. It cannot be mixed with unbuffered modules in the same system. Check your motherboard or NAS documentation to confirm it accepts DDR4 3200 registered ECC RDIMMs before ordering.
| Brand | OWC |
|---|---|
| Part Number | 3R2D41R808GB |
| Capacity | 8GB |
| Type | 288-Pin DDR4 ECC RDIMM |
| Speed | DDR4 3200 (PC4 25600) |
| CAS Latency | CL22 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 1Rx8 |
| Heat Spreader | No |
The module runs at 3200 MT/s with CL22 timing; ECC and registered operation add one cycle of buffering, so sustained bandwidth is limited by the JEDEC PC4-25600 rating rather than raw frequency alone
It fits a standard 288-pin DDR4 DIMM socket; no heat spreader is present, so low-profile heatsinks or tight server chassis lids will not interfere with the bare PCB
Power down, open the retention clips, align the single key notch, press firmly until both clips snap shut, then verify in BIOS that ECC and registered modes are enabled — the missed step is confirming the memory mode after boot
Aj v tomto oddelení
Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.
Mena, v ktorej platíte, a mena, v ktorej sa zobrazujú ceny.
Odoslané z vašej peňaženky na pokladni
Len na zobrazenie — katalóg je uvedený v dolároch
Žiadna mena nezodpovedá.
Vyberte jazyk, v ktorom s vami bude web komunikovať.
Ste tu prvýkrát?
Účet už máte?
Automatický reset hesla neexistuje: tento obchod neposiela žiadne e-maily, takže neexistuje jednorazový odkaz, o ktorý by ste mohli požiadať. Nechajte adresu na účte — niekto sa jej ujme ručne.
Žiadosť zaznamenaná
Do vašej schránky nič nepríde — tento obchod neposiela vôbec žiadne e-maily. Niekto sa o to postará ručne.
Spomenuli ste si?