Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.

Overvåkingsliste Logg inn
Four bare green DDR5 DIMM modules 288 pin 1.1V CL46

A-Tech

A-Tech 32GB Kit (4 x 8GB) DDR5 5600MHz CL46 1.1V Desktop RAM

SKU CH-CZSM-CMC8B

A 32 GB quad-channel DDR5 kit running at 5600 MHz with CL46 latency and 1.1 V operation

  • Capacity32GB (4 x 8GB)
  • SpeedDDR5 5600 (PC5 44800)
  • Tested Frequency5600
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCNo

Capacity 32GB (4 x 8GB)

Speed DDR5 5600 (PC5 44800)

CAS Latency CL46

  • CL40
  • CL42
  • CL46

Color

Overstrøkne versjoner finnes, men er ikke på lager her.

  • 32 GB capacity across four modules for heavy multitasking
  • DDR5 5600 MT/s tested speed for fast data throughput
  • CL46 latency at 1.1 V for efficient operation
  • 288-pin UDIMM form factor fits standard desktop DDR5 slots
  • Quad-channel kit layout maximises memory bandwidth

Kit Composition & Role

This A-Tech kit supplies 32GB of DDR5 desktop memory across four 8GB unbuffered DIMMs. The modules run at a tested 5600MHz with CL46 timings at the standard 1.10V. They are built with major-brand chips and carry no heat spreader, targeting mainstream system builders who want a straightforward capacity increase.

Fit & Alternatives

The quad-channel layout suits platforms that can address four slots natively, while the non-ECC unbuffered design matches typical consumer motherboards. Builders needing ECC error correction, registered modules, or lower-latency timings should look elsewhere, as should anyone whose board only supports dual-channel population.

Build Integration

Each module uses the 288-pin DDR5 DIMM form factor, so the motherboard must provide four compatible slots and a BIOS that recognises PC5-44800 speeds. The 1.10V operating voltage aligns with the DDR5 baseline, leaving headroom for the CPU memory controller. Populating all four slots maximises total capacity but may limit overclocking headroom compared to a two-module kit.

Høydepunkter

  • 32 GB capacity across four modules for heavy multitasking
  • DDR5 5600 MT/s tested speed for fast data throughput
  • CL46 latency at 1.1 V for efficient operation
  • 288-pin UDIMM form factor fits standard desktop DDR5 slots
  • Quad-channel kit layout maximises memory bandwidth

Spesifikasjoner

BrandA-Tech
SeriesA-Tech DDR5 Desktop Memory RAM
Capacity32GB (4 x 8GB)
SpeedDDR5 5600 (PC5 44800)
Tested Frequency5600
CAS LatencyCL46
Voltage1.10V
ECCNo
Buffered/RegisteredUnbuffered
Multi-channel KitQuad Channel Kit
ChipsetMajor Brand Chipset
Heat SpreaderNo
FeaturesMajor Brand Chips
Recommend UseAMD & Intel Compatible

Andre versjoner av denne modellen

5 flere i samme serie

Samme familie, annet minne, annen kjøler eller klokkefrekvens — sammenlign før du bestemmer deg.

Spørsmål om denne varen

Do I need a motherboard with DDR5 DIMM slots to use these 288-pin modules?

Yes, the kit requires a desktop motherboard that accepts DDR5 288-pin DIMMs and supports 5600 MT/s operation at 1.1 V.

Will these CL46 DDR5-5600 sticks run at their rated speed if I keep older DDR5-4800 modules in the other slots?

The memory controller will typically clock all installed DIMMs to the lowest common speed, so the 5600 MT/s modules would drop to 4800 MT/s alongside slower sticks.

How can I confirm the quad-channel kit is running at 5600 MT/s with CL46 timings after installation?

Open the BIOS or a system-information tool such as CPU-Z and verify the memory frequency reads 5600 MT/s and the CAS latency shows 46.

Også i denne avdelingen

Kunder sammenlignet disse

Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.