NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.
ASRock
8GB GDDR6 card with 2304 stream processors, up to 1750 MHz boost, 256-bit bus, 3 DisplayPort 1.4 and HDMI 2.0b for 8K 60 Hz, dual 8-pin power, 281 x 137 x 42 mm
The ASRock Challenger D 8G OC uses the AMD Radeon RX 5700 core built on a second-generation 7nm process with RDNA architecture. It provides 8GB of 256-bit GDDR6 memory running at 14 Gbps and 2304 stream processors. PCI Express 4.0 support and DirectX 12 compatibility suit modern 1440p gaming builds. Outputs include three DisplayPort 1.4 and one HDMI 2.0b for up to four displays.
Moving to this card from a 1080p-class GPU adds the memory bandwidth and compute needed for higher resolutions and refresh rates. The jump is worth it when your monitor exceeds 1080p or when titles demand more than 4GB VRAM. Base frequency sits at 1515 MHz with gaming frequency up to 1675 MHz and dynamic speedup up to 1750 MHz. A 600W power supply and two 8-pin connectors are required.
At 281 x 137 x 42mm the card fits most mid-tower cases and uses a conventional dual-slot bracket. Installation follows the usual PCIe x16 seat and two 8-pin power cables; a quick installation guide is included. Common issues are forgetting the second power connector or using a PSU below the 600W recommendation. Ensure the case has clearance for the 281mm length before ordering.
| Memory Size | 8GB |
|---|---|
| Memory Type | GDDR6 |
The card measures 281 mm long, 137 mm wide and 42 mm thick. Check your chassis clearance against those dimensions and ensure two 8-pin power cables can reach the connectors.
Align the gold edge connector with the motherboard PCIe 4.0 slot, press down until the retention clip clicks, then firmly connect both 8-pin power cables from the PSU; forgetting either plug will prevent the card from starting.
Re-paste if temperatures rise noticeably after a few years or when you disassemble the cooler for cleaning; use a pea-sized dot of non-conductive paste on the 2304-stream-processor die.
Også i denne avdelingen
Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.
Det du betaler med, og det du ser prisene i.
Sendes fra lommeboken din i kassen
Kun visning — katalogen er prissatt i USD
Fant ingen valuta.
Velg språket nettstedet snakker til deg på.
Ny her?
Har du allerede en konto?
Det finnes ingen automatisk tilbakestilling: butikken sender ikke e-post, så det finnes ingen engangslenke å be om. La adressen stå på kontoen, så blir den behandlet manuelt.
Forespørsel registrert
Ingenting er på vei til innboksen din — butikken sender ingen e-post i det hele tatt. Noen behandler dette manuelt.
Husket du det likevel?