Micron Technology, Inc. MT4JTF12864AZ-1G4D1 1GB DDR3 1333 Desktop RAM
- 1GB
- DDR3 1333 (PC3 1060…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
ASRock
8GB GDDR6 card with 2304 stream processors, up to 1750 MHz boost, 256-bit bus, 3 DisplayPort 1.4 and HDMI 2.0b for 8K 60 Hz, dual 8-pin power, 281 x 137 x 42 mm
The ASRock Challenger D 8G OC uses the AMD Radeon RX 5700 core built on a second-generation 7nm process with RDNA architecture. It provides 8GB of 256-bit GDDR6 memory running at 14 Gbps and 2304 stream processors. PCI Express 4.0 support and DirectX 12 compatibility suit modern 1440p gaming builds. Outputs include three DisplayPort 1.4 and one HDMI 2.0b for up to four displays.
Moving to this card from a 1080p-class GPU adds the memory bandwidth and compute needed for higher resolutions and refresh rates. The jump is worth it when your monitor exceeds 1080p or when titles demand more than 4GB VRAM. Base frequency sits at 1515 MHz with gaming frequency up to 1675 MHz and dynamic speedup up to 1750 MHz. A 600W power supply and two 8-pin connectors are required.
At 281 x 137 x 42mm the card fits most mid-tower cases and uses a conventional dual-slot bracket. Installation follows the usual PCIe x16 seat and two 8-pin power cables; a quick installation guide is included. Common issues are forgetting the second power connector or using a PSU below the 600W recommendation. Ensure the case has clearance for the 281mm length before ordering.
| Memory Size | 8GB |
|---|---|
| Memory Type | GDDR6 |
The card measures 281 mm long, 137 mm wide and 42 mm thick. Check your chassis clearance against those dimensions and ensure two 8-pin power cables can reach the connectors.
Align the gold edge connector with the motherboard PCIe 4.0 slot, press down until the retention clip clicks, then firmly connect both 8-pin power cables from the PSU; forgetting either plug will prevent the card from starting.
Re-paste if temperatures rise noticeably after a few years or when you disassemble the cooler for cleaning; use a pea-sized dot of non-conductive paste on the 2304-stream-processor die.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?