NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.
Brute Networks
8GB DDR4-2133 ECC registered RDIMM with CL15 latency and 1.2V operation for compatible servers
This 8 GB DDR4-2133 registered DIMM adds ECC-protected capacity to compatible HP servers. It is built for administrators who need to extend the life of existing rack infrastructure without replacing the chassis. The module uses major-brand DRAM and matches the 759935-B21 part number for drop-in installation. Buyers who need non-ECC or unbuffered memory for workstations cannot use this part.
The module operates at the standard DDR4 voltage of 1.20 V, keeping power draw low inside dense server enclosures. Registered buffering reduces electrical load on the memory controller, which helps maintain stable thermals across fully populated channels. No active cooling is required on the DIMM itself; airflow provided by the server chassis is sufficient. Systems that demand higher-voltage or unregistered modules will not support this DIMM.
The stick is a 288-pin DDR4 SDRAM rated at 2133 MT/s (PC4-17000) with CL15 latency and a 2Rx8 organisation. ECC and registered signalling are mandatory for the target platform, so the motherboard must support both features. Mixing ranks or speeds may prevent the server from posting. Buyers whose systems require a different rank configuration or speed grade must select another module.
| Brand | HP |
|---|---|
| Capacity | 8GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
Align the notch on the 288-Pin DDR4 module with the slot key, press firmly until both retention clips click, and verify the system registers the full 8GB at 2133 MT/s; the step often missed is seating both ends evenly so the registered buffer initialises correctly.
No routine maintenance is required; the module uses major-brand DRAM chips rated for continuous server operation, and ECC corrects single-bit errors on the fly, so replacement is only needed if a multi-bit fault exceeds correction capability.
The CAS latency of 15 cycles at 2133 MT/s sets the timing floor, and the 1.20V supply caps thermal headroom, so latency and voltage constraints surface before bandwidth saturates under prolonged load.
Også i denne avdelingen
Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.
Det du betaler med, og det du ser prisene i.
Sendes fra lommeboken din i kassen
Kun visning — katalogen er prissatt i USD
Fant ingen valuta.
Velg språket nettstedet snakker til deg på.
Ny her?
Har du allerede en konto?
Det finnes ingen automatisk tilbakestilling: butikken sender ikke e-post, så det finnes ingen engangslenke å be om. La adressen stå på kontoen, så blir den behandlet manuelt.
Forespørsel registrert
Ingenting er på vei til innboksen din — butikken sender ingen e-post i det hele tatt. Noen behandler dette manuelt.
Husket du det likevel?