Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green 288-pin DDR4 RDIMM module with black chips

Brute Networks

Brute Networks 8GB DDR4-2133 ECC Registered RDIMM 2Rx8

SKU CH-VQDB-Z3NDH

8GB DDR4-2133 ECC registered RDIMM with CL15 latency and 1.2V operation for compatible servers

  • Capacity8GB
  • Type288-Pin DDR4 SDRAM
  • SpeedDDR4 2133 (PC4 17000)
  • CAS LatencyCL15
  • Voltage1.20V
  • ECCYes
  • 8GB capacity expands server workloads
  • DDR4-2133 speed matches PC4-17000 rating
  • ECC registered design protects data integrity
  • 2Rx8 dual-rank layout increases density
  • 20V operation reduces power draw

Server Memory Upgrade

This 8 GB DDR4-2133 registered DIMM adds ECC-protected capacity to compatible HP servers. It is built for administrators who need to extend the life of existing rack infrastructure without replacing the chassis. The module uses major-brand DRAM and matches the 759935-B21 part number for drop-in installation. Buyers who need non-ECC or unbuffered memory for workstations cannot use this part.

Thermals and Power

The module operates at the standard DDR4 voltage of 1.20 V, keeping power draw low inside dense server enclosures. Registered buffering reduces electrical load on the memory controller, which helps maintain stable thermals across fully populated channels. No active cooling is required on the DIMM itself; airflow provided by the server chassis is sufficient. Systems that demand higher-voltage or unregistered modules will not support this DIMM.

Critical Specification

The stick is a 288-pin DDR4 SDRAM rated at 2133 MT/s (PC4-17000) with CL15 latency and a 2Rx8 organisation. ECC and registered signalling are mandatory for the target platform, so the motherboard must support both features. Mixing ranks or speeds may prevent the server from posting. Buyers whose systems require a different rank configuration or speed grade must select another module.

Kohokohdat

  • 8GB capacity expands server workloads
  • DDR4-2133 speed matches PC4-17000 rating
  • ECC registered design protects data integrity
  • 2Rx8 dual-rank layout increases density
  • 20V operation reduces power draw

Tekniset tiedot

BrandHP
Capacity8GB
Type288-Pin DDR4 SDRAM
SpeedDDR4 2133 (PC4 17000)
CAS LatencyCL15
Voltage1.20V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor Brand Chipset

Kysymyksiä tästä tuotteesta

How do I install this 288-Pin DDR4 RDIMM in my server, and what step do people often miss?

Align the notch on the 288-Pin DDR4 module with the slot key, press firmly until both retention clips click, and verify the system registers the full 8GB at 2133 MT/s; the step often missed is seating both ends evenly so the registered buffer initialises correctly.

What maintenance or replacement will this 8GB 2Rx8 ECC Registered module need over its service life?

No routine maintenance is required; the module uses major-brand DRAM chips rated for continuous server operation, and ECC corrects single-bit errors on the fly, so replacement is only needed if a multi-bit fault exceeds correction capability.

What limit appears first when this CL15 1.20V RDIMM runs sustained workloads?

The CAS latency of 15 cycles at 2133 MT/s sets the timing floor, and the 1.20V supply caps thermal headroom, so latency and voltage constraints surface before bandwidth saturates under prolonged load.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.