Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.

Overvåkingsliste Logg inn
Silver rectangular ATX power supply unit with ventilation grilles and rear connector panel

KHACHIMO

KHACHIMO TDR-960-24 24V 40A power supply

SKU CH-D8XH-XCBXE

Delivers 24V at 40A for 960W in an ATX form factor, tested working

  • TypeATX
  • Delivers 960 W continuous power for demanding 24 V systems
  • Provides 40 A output current to drive high-load equipment reliably
  • ATX form factor fits standard chassis mounting points
  • Tested working and built with good quality components

KHACHIMO TDR-960-24 24V 40A unit

This KHACHIMO power supply delivers 24 V at up to 40 A for industrial or test-bench use. It is built as an ATX-type switch-mode unit and has been test-verified for reliable operation. Buyers needing a different output voltage or a redundant hot-swap design should look elsewhere.

960 W capacity and headroom

The 960 W rating gives comfortable headroom for loads drawing up to the full 40 A at 24 V. Continuous operation at the maximum current is supported, but sustained loads beyond that rating will trigger protection or shutdown. Systems requiring higher peak power or multiple isolated rails are not suited to this single-output model.

Høydepunkter

  • Delivers 960 W continuous power for demanding 24 V systems
  • Provides 40 A output current to drive high-load equipment reliably
  • ATX form factor fits standard chassis mounting points
  • Tested working and built with good quality components

Spesifikasjoner

TypeATX

Spørsmål om denne varen

Will the KHACHIMO TDR-960-24 fit in my existing ATX case?

Yes, the unit follows the ATX form factor so it mounts in standard ATX chassis and uses the same screw pattern as older ATX supplies.

How can I verify the 24V 40A output is stable after installation?

Measure the DC output with a multimeter under load; it should read close to 24 V and deliver up to 40 A without shutting down.

Også i denne avdelingen

Kunder sammenlignet disse

Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.