Wij accepteren cryptovaluta — zo kunnen de munten die u bezit echte hardware kopen.Betaal in crypto, besteed het aan echte hardware. Gratis verzekerde verzending wereldwijd vanaf $399. Neutrale dozen zonder merk, verzonden vanuit Duitsland.Gratis verzekerde verzending vanaf $399. Uw koers wordt 30 minuten vastgezet zodra het afrekenen begint.Koers 30 minuten vastgezet. Elk artikel is verzegeld, het serienummer wordt gecontroleerd, en het valt onder 24 maanden garantie.Verzegeld, 24 maanden garantie.

Favoriete artikelen Inloggen
Silver rectangular ATX power supply unit with ventilation grilles and rear connector panel

KHACHIMO

KHACHIMO TDR-960-24 24V 40A power supply

SKU CH-D8XH-XCBXE

Delivers 24V at 40A for 960W in an ATX form factor, tested working

  • TypeATX
  • Delivers 960 W continuous power for demanding 24 V systems
  • Provides 40 A output current to drive high-load equipment reliably
  • ATX form factor fits standard chassis mounting points
  • Tested working and built with good quality components

KHACHIMO TDR-960-24 24V 40A unit

This KHACHIMO power supply delivers 24 V at up to 40 A for industrial or test-bench use. It is built as an ATX-type switch-mode unit and has been test-verified for reliable operation. Buyers needing a different output voltage or a redundant hot-swap design should look elsewhere.

960 W capacity and headroom

The 960 W rating gives comfortable headroom for loads drawing up to the full 40 A at 24 V. Continuous operation at the maximum current is supported, but sustained loads beyond that rating will trigger protection or shutdown. Systems requiring higher peak power or multiple isolated rails are not suited to this single-output model.

Pluspunten

  • Delivers 960 W continuous power for demanding 24 V systems
  • Provides 40 A output current to drive high-load equipment reliably
  • ATX form factor fits standard chassis mounting points
  • Tested working and built with good quality components

Specificaties

TypeATX

Vragen over dit artikel

Will the KHACHIMO TDR-960-24 fit in my existing ATX case?

Yes, the unit follows the ATX form factor so it mounts in standard ATX chassis and uses the same screw pattern as older ATX supplies.

How can I verify the 24V 40A output is stable after installation?

Measure the DC output with a multimeter under load; it should read close to 24 V and deliver up to 40 A without shutting down.

Ook in deze afdeling

Klanten vergeleken ook

Dezelfde afdeling, dezelfde kassa — acht munten en een koers die 30 minuten vaststaat.