NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.
LORDWORLD
Flexible 64×64 RGB LED matrix with 4096 addressable pixels on a bendable 3 mm pitch PCB, HUB75 chainable for Raspberry Pi, ESP32 and Arduino projects
The LORDWORLD panel packs 4096 addressable RGB LEDs onto a bendable PCB with a 3mm pitch. Makers and developers can curve the 192×192mm surface around cylinders or spheres for custom display projects. It targets hobbyists building animated signs, wearable prototypes, or interactive art installations.
Two HUB75 headers sit on the board — one for data input and one for output — so multiple panels link in series from a single controller. The flexible substrate tolerates gentle bends without trace damage, making curved mounts practical for desktop or wall installations. No rigid frame is required.
At 3mm pixel spacing the 64×64 resolution stays sharp only at close viewing distances; fine text blurs beyond arm's length. Chaining panels increases total pixel count but each added panel raises refresh-rate demand on the host controller. The panel lacks onboard memory or a driver IC, so the host must stream frame data continuously.
| Brand | LORDWORLD |
|---|
The panel uses dual HUB75 headers for input and output, allowing multiple 64×64 panels to be chained together; the practical chain length depends on the controller's RAM and refresh-rate requirements.
The 192×192 mm panel can be gently bent around cylinders or spheres and includes mounting holes for flat wall or desktop installation; allow extra depth for the HUB75 connectors and power wiring.
Connect the input HUB75 header to the controller's GPIO using a compatible adapter or HAT, supply 5 V power separately to the panel's power terminals, and ensure the controller ground is common with the panel ground — the shared ground is the step most often missed.
Også i denne avdelingen
Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.
Det du betaler med, og det du ser prisene i.
Sendes fra lommeboken din i kassen
Kun visning — katalogen er prissatt i USD
Fant ingen valuta.
Velg språket nettstedet snakker til deg på.
Ny her?
Har du allerede en konto?
Det finnes ingen automatisk tilbakestilling: butikken sender ikke e-post, så det finnes ingen engangslenke å be om. La adressen stå på kontoen, så blir den behandlet manuelt.
Forespørsel registrert
Ingenting er på vei til innboksen din — butikken sender ingen e-post i det hele tatt. Noen behandler dette manuelt.
Husket du det likevel?