Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.

Overvåkingsliste Logg inn
Silver 2U modular mining PSU with ten 6-pin connectors

myVolts

myVolts 1800W 2U Modular Mining PSU 10x6Pin

SKU CH-67WR-VX6ZJ

Modular 1800 W AT power supply with ten 6-pin connectors and 95 % conversion efficiency

  • TypeAT
  • 1800W output powers up to 10 mining devices simultaneously
  • 95% conversion efficiency lowers electricity costs versus typical passive PFC units
  • 10 six-pin connectors eliminate adapter clutter for GPU rigs
  • Automatic shutdown protects hardware during circuit faults or overheating
  • 100–240V AC input works on global mains without switching

Mining power supply with ten 6-pin connectors

The myVolts 1800 W modular PSU delivers up to 1800 watts of 12 V DC power from a 110–230 V AC source. It uses a 95 % conversion rate to keep electricity costs lower than passive PFC designs. An aluminium shell and all-copper transformer windings help the unit run cooler and last longer. Automatic shutdown triggers if a circuit fault or excessive internal temperature is detected.

Suitable for GPU mining rigs that need ten 6-pin

Miners powering Antminer S9, L3+, Z9 Mini or D3 units can connect each hash board directly without extra splitters. The 60 mm high-speed fan moves plenty of air, but the noise level is noticeable during full-load operation. Builds requiring more than ten connectors or any 8-pin or 12VHPWR leads cannot use this PSU as-is. Server installations needing redundant hot-swap modules should look at a different form factor.

Ten 6-pin outputs on a single 12 V rail

Every connector draws from the same 1800 W 12 V rail, so total load must stay within that limit. The 120 cm AC cord reaches most rack PDUs without an extension. Input voltage auto-ranges from 100 to 240 V, making the unit usable worldwide. Efficiency stays at or above 95 % across the load range, reducing waste heat and operating cost.

Høydepunkter

  • 1800W output powers up to 10 mining devices simultaneously
  • 95% conversion efficiency lowers electricity costs versus typical passive PFC units
  • 10 six-pin connectors eliminate adapter clutter for GPU rigs
  • Automatic shutdown protects hardware during circuit faults or overheating
  • 100–240V AC input works on global mains without switching

Spesifikasjoner

TypeAT

Spørsmål om denne varen

Which capacity should I pick for an 8-GPU mining rig?

The unit delivers 1800W on the 12V rail, matching the spec for eight GPUs with ten 6-pin connectors included.

What does the 95% conversion rate mean once the PSU is installed?

It indicates 95% or higher AC-to-DC efficiency, so less power is lost as heat and electricity costs are lower than typical passive PFC designs.

What does the 110-230V AC input range cap in practice?

The PSU auto-ranges between 110V and 230V mains, allowing worldwide use without a voltage switch while feeding a steady 12V DC output.

Også i denne avdelingen

Kunder sammenlignet disse

Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.