Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.

Overvåkingsliste Logg inn
Compact Pico PSU module with 24-pin ATX connector and short 25cm cable

myVolts

myVolts Pico PSU 250W 12V DC ATX 24-pin 25cm

SKU CH-TKNF-MWSD9

Compact 150–250W DC-to-ATX converter powers mini-ITX boards from a 12V source with a 25cm cable

  • TypeAT
  • Cable Spec25cm
  • Delivers up to 250 W from a 12 V DC source
  • 24-pin ATX plug connects straight to the motherboard
  • 25 cm cable keeps Mini-ITX builds tidy
  • circuit protection shuts down output on fault
  • 5 mm / 5.5 mm barrel jack fits common 12 V adapters

Compact 250 W DC-ATX power module

The myVolts Pico PSU delivers up to 250 watts from a 12 volt DC source through a 24-pin ATX connector. It is aimed at builders of Mini-ITX systems, embedded PCs or vehicle installations where a standard AC power supply is impractical. The 25 centimetre cable keeps routing tidy inside small chassis. Short-circuit protection shuts down the output if a fault occurs.

Replaces bulky AC units in space-constrained builds

This module removes the need for a full-size ATX power supply when the system runs from a 12 volt DC supply such as a vehicle electrical system or an external DC brick. The jump is worthwhile when chassis volume is at a premium and the total component draw stays within the 150 to 250 watt range. It is not for systems that require AC mains input or that exceed the rated DC output capacity.

Plugs straight into the board

Installation consists of connecting the 24-pin ATX plug to the motherboard and the barrel jack to a compatible 12 volt source; no additional cables or adapters are included. The 25 centimetre lead length suits Mini-ITX layouts but may fall short in larger cases. The most common issue is mismatching the barrel connector polarity or inner/outer diameter, so verify the source plug before powering on.

Høydepunkter

  • Delivers up to 250 W from a 12 V DC source
  • 24-pin ATX plug connects straight to the motherboard
  • 25 cm cable keeps Mini-ITX builds tidy
  • circuit protection shuts down output on fault
  • 5 mm / 5.5 mm barrel jack fits common 12 V adapters

Spesifikasjoner

TypeAT
Cable Spec25cm

Spørsmål om denne varen

What size DC barrel plug does the 12V input require?

The unit uses a 5.5mm outer diameter and 2.5mm inner diameter barrel connector for the 12V DC input.

How does the 24-pin ATX connector attach to the motherboard?

The 24-pin ATX plug inserts directly into the board socket with no adapter cable needed.

What happens if a short circuit occurs on the output rails?

Short-circuit protection shuts down the output immediately until the fault is cleared.

Også i denne avdelingen

Kunder sammenlignet disse

Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.