Vi tar emot kryptovaluta — så att kryptot du äger kan köpa riktig hårdvara.Betala med krypto, använd det till riktig hårdvara. Fri, försäkrad frakt över hela världen vid köp över 399 $. Neutrala, omärkta ytterkartonger, skickade från Tyskland.Fri, försäkrad frakt över 399 $. Din kurs låses i 30 minuter så snart kassan öppnas.Kursen låst i 30 minuter. Varje artikel är förseglad, har kontrollerat serienummer och täcks av 24 månaders garanti.Förseglad, 24 månaders garanti.

Bevakade produkter Logga in
Compact Pico PSU module with 24-pin ATX connector and short 25cm cable

myVolts

myVolts Pico PSU 250W 12V DC ATX 24-pin 25cm

SKU CH-TKNF-MWSD9

Compact 150–250W DC-to-ATX converter powers mini-ITX boards from a 12V source with a 25cm cable

  • TypeAT
  • Cable Spec25cm
  • Delivers up to 250 W from a 12 V DC source
  • 24-pin ATX plug connects straight to the motherboard
  • 25 cm cable keeps Mini-ITX builds tidy
  • circuit protection shuts down output on fault
  • 5 mm / 5.5 mm barrel jack fits common 12 V adapters

Compact 250 W DC-ATX power module

The myVolts Pico PSU delivers up to 250 watts from a 12 volt DC source through a 24-pin ATX connector. It is aimed at builders of Mini-ITX systems, embedded PCs or vehicle installations where a standard AC power supply is impractical. The 25 centimetre cable keeps routing tidy inside small chassis. Short-circuit protection shuts down the output if a fault occurs.

Replaces bulky AC units in space-constrained builds

This module removes the need for a full-size ATX power supply when the system runs from a 12 volt DC supply such as a vehicle electrical system or an external DC brick. The jump is worthwhile when chassis volume is at a premium and the total component draw stays within the 150 to 250 watt range. It is not for systems that require AC mains input or that exceed the rated DC output capacity.

Plugs straight into the board

Installation consists of connecting the 24-pin ATX plug to the motherboard and the barrel jack to a compatible 12 volt source; no additional cables or adapters are included. The 25 centimetre lead length suits Mini-ITX layouts but may fall short in larger cases. The most common issue is mismatching the barrel connector polarity or inner/outer diameter, so verify the source plug before powering on.

I korthet

  • Delivers up to 250 W from a 12 V DC source
  • 24-pin ATX plug connects straight to the motherboard
  • 25 cm cable keeps Mini-ITX builds tidy
  • circuit protection shuts down output on fault
  • 5 mm / 5.5 mm barrel jack fits common 12 V adapters

Specifikationer

TypeAT
Cable Spec25cm

Frågor om den här produkten

What size DC barrel plug does the 12V input require?

The unit uses a 5.5mm outer diameter and 2.5mm inner diameter barrel connector for the 12V DC input.

How does the 24-pin ATX connector attach to the motherboard?

The 24-pin ATX plug inserts directly into the board socket with no adapter cable needed.

What happens if a short circuit occurs on the output rails?

Short-circuit protection shuts down the output immediately until the fault is cleared.

Även i den här avdelningen

Andra har jämfört dessa

Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.