Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.

Overvåkingsliste Logg inn
Green circuit board with black memory chips, gold edge connector, no heat spreader

OWC

OWC 2U6D41R808GB 8GB DDR4 2666MHz CL19 1.2V 288-Pin UDIMM for HP 290 G1 G2 G3 G4 295 G6 memory upgrade

SKU CH-ZXDR-8X87K

8GB DDR4 2666MHz CL19 UDIMM upgrades HP 290 and 295 desktops with JEDEC-compliant 1.2V memory

  • Capacity8GB
  • Type288-Pin DDR4 Non-ECC UDIMM
  • SpeedDDR4 2666 (PC4 21300)
  • CAS LatencyCL19
  • Voltage1.2V
  • ECCNo
  • 8GB capacity boosts multitasking across HP 290 and 295 desktops
  • DDR4 2666MHz CL19 timing delivers responsive system performance
  • 2V operation reduces power draw versus higher-voltage modules
  • 288-pin UDIMM fits HP 290 G1 G2 G3 G4 and 295 G6 directly
  • JEDEC compliant and backward compatible with 2133MHz and 2400MHz speeds

OWC 8GB DDR4 for HP 290 and 295

This OWC module adds 8GB of DDR4 memory to HP 290 G1 through G4 and HP 295 G6 desktops. It targets owners of those specific models who need a straightforward capacity increase. Buyers with other platforms or laptops cannot use this UDIMM.

JEDEC compliant 288 pin unbuffered DIMM

The stick follows JEDEC PC4-21300 specifications at 2666MHz CL19 and runs at 1.2V without a heat spreader. Its 288 pin unbuffered non ECC design fits standard desktop slots and will also operate in systems rated for 2133MHz or 2400MHz. Systems requiring ECC or registered memory are not supported.

Lifetime warranty and installation video

OWC backs the module with a limited lifetime warranty and an advanced replacement programme plus free technical support. An online installation video guides first time upgraders through the process. No extra cables, brackets or software licences are included.

Høydepunkter

  • 8GB capacity boosts multitasking across HP 290 and 295 desktops
  • DDR4 2666MHz CL19 timing delivers responsive system performance
  • 2V operation reduces power draw versus higher-voltage modules
  • 288-pin UDIMM fits HP 290 G1 G2 G3 G4 and 295 G6 directly
  • JEDEC compliant and backward compatible with 2133MHz and 2400MHz speeds

Spesifikasjoner

BrandOWC
Part Number2U6D41R808GB
Capacity8GB
Type288-Pin DDR4 Non-ECC UDIMM
SpeedDDR4 2666 (PC4 21300)
CAS LatencyCL19
Voltage1.2V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx8
Heat SpreaderNo
Compatible SystemHP 290 G1
HP 290 G2
HP 290 G3
HP 290 G4
HP 295 G6

Andre versjoner av denne modellen

5 flere i samme serie

Samme familie, annet minne, annen kjøler eller klokkefrekvens — sammenlign før du bestemmer deg.

Spørsmål om denne varen

What speed does the PC4-21300 DDR4 2666MHz module actually run at in an HP 290 G3?

It will operate at 2666MHz CL19 at 1.2V; if the platform only supports 2400MHz or 2133MHz the JEDEC SPD automatically down-clocks to the highest speed the board allows.

Will the 288-pin unbuffered UDIMM fit the HP 295 G6 chassis without a heat spreader?

Yes, the bare 288-pin UDIMM is the standard desktop form factor used by the 295 G6; no spreader means it clears even low-profile CPU coolers.

Which slot should I populate first on the HP 290 G4 for a single 8GB stick?

Install the module in the DIMM slot closest to the CPU socket — usually labelled DIMM1 or Channel A Slot 0 — so the memory controller trains at 2666MHz instead of falling back to a lower speed.

Også i denne avdelingen

Kunder sammenlignet disse

Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.