Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Green circuit board with black memory chips, gold edge connector, no heat spreader

OWC

OWC 2U6D41R808GB 8GB DDR4 2666MHz CL19 1.2V 288-Pin UDIMM for HP 290 G1 G2 G3 G4 295 G6 memory upgrade

SKU CH-ZXDR-8X87K

8GB DDR4 2666MHz CL19 UDIMM upgrades HP 290 and 295 desktops with JEDEC-compliant 1.2V memory

  • Capacity8GB
  • Type288-Pin DDR4 Non-ECC UDIMM
  • SpeedDDR4 2666 (PC4 21300)
  • CAS LatencyCL19
  • Voltage1.2V
  • ECCNo
  • 8GB capacity boosts multitasking across HP 290 and 295 desktops
  • DDR4 2666MHz CL19 timing delivers responsive system performance
  • 2V operation reduces power draw versus higher-voltage modules
  • 288-pin UDIMM fits HP 290 G1 G2 G3 G4 and 295 G6 directly
  • JEDEC compliant and backward compatible with 2133MHz and 2400MHz speeds

OWC 8GB DDR4 for HP 290 and 295

This OWC module adds 8GB of DDR4 memory to HP 290 G1 through G4 and HP 295 G6 desktops. It targets owners of those specific models who need a straightforward capacity increase. Buyers with other platforms or laptops cannot use this UDIMM.

JEDEC compliant 288 pin unbuffered DIMM

The stick follows JEDEC PC4-21300 specifications at 2666MHz CL19 and runs at 1.2V without a heat spreader. Its 288 pin unbuffered non ECC design fits standard desktop slots and will also operate in systems rated for 2133MHz or 2400MHz. Systems requiring ECC or registered memory are not supported.

Lifetime warranty and installation video

OWC backs the module with a limited lifetime warranty and an advanced replacement programme plus free technical support. An online installation video guides first time upgraders through the process. No extra cables, brackets or software licences are included.

Přednosti

  • 8GB capacity boosts multitasking across HP 290 and 295 desktops
  • DDR4 2666MHz CL19 timing delivers responsive system performance
  • 2V operation reduces power draw versus higher-voltage modules
  • 288-pin UDIMM fits HP 290 G1 G2 G3 G4 and 295 G6 directly
  • JEDEC compliant and backward compatible with 2133MHz and 2400MHz speeds

Specifikace

BrandOWC
Part Number2U6D41R808GB
Capacity8GB
Type288-Pin DDR4 Non-ECC UDIMM
SpeedDDR4 2666 (PC4 21300)
CAS LatencyCL19
Voltage1.2V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx8
Heat SpreaderNo
Compatible SystemHP 290 G1
HP 290 G2
HP 290 G3
HP 290 G4
HP 295 G6

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

What speed does the PC4-21300 DDR4 2666MHz module actually run at in an HP 290 G3?

It will operate at 2666MHz CL19 at 1.2V; if the platform only supports 2400MHz or 2133MHz the JEDEC SPD automatically down-clocks to the highest speed the board allows.

Will the 288-pin unbuffered UDIMM fit the HP 295 G6 chassis without a heat spreader?

Yes, the bare 288-pin UDIMM is the standard desktop form factor used by the 295 G6; no spreader means it clears even low-profile CPU coolers.

Which slot should I populate first on the HP 290 G4 for a single 8GB stick?

Install the module in the DIMM slot closest to the CPU socket — usually labelled DIMM1 or Channel A Slot 0 — so the memory controller trains at 2666MHz instead of falling back to a lower speed.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.