Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.

Overvåkingsliste Logg inn
Four black DDR3 desktop memory modules side by side

Timetec

Timetec 32GB Kit (4x8GB) DDR3/DDR3L 1333MHz Desktop RAM

SKU CH-9VS2-01VHH

A 32 GB desktop memory kit of four 8 GB DDR3/DDR3L modules running at 1333 MHz with CL9 latency and dual-voltage 1.35 V or 1.5 V operation

  • Capacity32GB (4 x 8GB)
  • SpeedDDR3 1333 (PC3 10600)
  • ColorBlack PCB

Capacity 32GB (4 x 8GB)

Speed DDR3 1333

Color Black PCB

  • 32 GB total capacity from four 8 GB modules
  • Dual-voltage operation at 1.35 V or 1.5 V for wider DDR3/DDR3L compatibility
  • CL9 latency at 1333 MHz for responsive multitasking
  • 240-pin UDIMM form factor fits standard desktop DIMM slots
  • Rigorously tested ICs deliver stable performance under load

Kit Composition

This Timetec kit supplies 32 GB of desktop memory in four 8 GB modules. It uses DDR3 and DDR3L dual-voltage parts rated at 1333 MHz PC3-10600 with CL9 latency. Each stick is a 240-pin non-ECC unbuffered UDIMM built with 2Rx8 dual-rank chips. The PCB colour may be black or green depending on the production batch.

Suitability

The pack suits owners of DDR3 desktop boards that accept 1.35 V or 1.5 V unbuffered DIMMs and have four free slots for a full 32 GB upgrade. Builders working with laptops, systems limited to two slots, or platforms requiring ECC or registered memory cannot use this kit. Buyers needing higher frequencies or lower latencies should look at other modules.

Deciding Specification

The dual-voltage 1.35 V / 1.5 V rating is the single figure that decides compatibility. A motherboard must support one of these JEDEC voltages for the modules to operate correctly. If the board only accepts a different voltage the kit will not work.

Høydepunkter

  • 32 GB total capacity from four 8 GB modules
  • Dual-voltage operation at 1.35 V or 1.5 V for wider DDR3/DDR3L compatibility
  • CL9 latency at 1333 MHz for responsive multitasking
  • 240-pin UDIMM form factor fits standard desktop DIMM slots
  • Rigorously tested ICs deliver stable performance under load

Spesifikasjoner

Capacity32GB (4 x 8GB)
SpeedDDR3 1333 (PC3 10600)
ColorBlack PCB

Andre versjoner av denne modellen

5 flere i samme serie

Samme familie, annet minne, annen kjøler eller klokkefrekvens — sammenlign før du bestemmer deg.

Spørsmål om denne varen

Does my motherboard need four free 240-pin DDR3 slots to use all four 8 GB modules?

Yes, the kit contains four 240-pin UDIMMs so you need four available DDR3 desktop slots.

If I keep my existing 1333 MHz DDR3 sticks, will this kit run at the same speed?

The modules are rated for 1333 MHz CL9 at 1.5 V or 1.35 V; the system will run all sticks at the lowest common speed and timings.

How can I verify the kit is running at 1333 MHz with CL9 timings after installation?

Enter the BIOS or use a tool like CPU-Z and check that the DRAM frequency shows 1333 MT/s and CAS latency reads 9.

Også i denne avdelingen

Kunder sammenlignet disse

Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.