Fans
Fans TA450DC A34349-57G1 12cm 12025 24V 0.15A double ball bearing 3-wire case fan
19,99 USD
0.00025658BTC
På lager
Zyvpee
Zyvpee CHA8024EBN-K(E) 8025 80*25mm 24V .24A 2 Pin case fan
An 80 mm square case fan with ball-bearing motor, 24 V .24 A draw and a two-pin power connector
- TypeCase Fan
- CompatibilityCase
- Bearing TypeBall
- Power Connector2 Pin
- ColorBlack
- LEDNon-LED
- Ball-bearing design for long-lasting reliability
- 24 V, 0.24 A draw suits industrial 24 V rails
- Compact 80 × 25 mm frame fits tight chassis spaces
- Two-pin connector enables simple voltage control
- Non-LED black finish keeps builds clean and professional
Compact 80 mm case fan for 24 V systems
The Zyvpee CHA8024EBN-K(E) is an 80 by 25 mm DC axial fan built for computer cases that run on a 24 V supply. It draws 0.24 A through a two-pin connector and uses a ball bearing for continuous rotation. The black frame carries no lighting, making it suitable for industrial or server builds where illumination is not required.
Two-wire power cable simplifies wiring
The bundled two-pin lead plugs directly into a compatible 24 V header or terminal block, so no adapter or PWM controller is needed. Because the fan has no LED circuit, the cable carries only power and ground, reducing the chance of a misconnected signal wire. The ball bearing is lubricated for long life in always-on environments.
Straightforward screw mounting with polarity care
Four corner holes accept standard M3 screws for 80 mm fan positions, and the 25 mm thickness fits most slim chassis slots. Installers must verify that the supply is 24 V and observe the red and black wire polarity, as the two-pin plug has no keying. Reversing the wires will prevent the motor from starting.
Høydepunkter
- Ball-bearing design for long-lasting reliability
- 24 V, 0.24 A draw suits industrial 24 V rails
- Compact 80 × 25 mm frame fits tight chassis spaces
- Two-pin connector enables simple voltage control
- Non-LED black finish keeps builds clean and professional
Spesifikasjoner
| Series | CHA8024EBN-K(E) |
|---|---|
| Model | CHA8024EBN-K(E) |
| Type | Case Fan |
| Compatibility | Case |
| Bearing Type | Ball |
| Power Connector | 2 Pin |
| Color | Black |
| LED | Non-LED |
| Features | DC axial fan |
| Dimensions | 80*80*25mm |
Spørsmål om denne varen
How often should the ball bearing in this 80*25mm fan be replaced?
The ball bearing is rated for continuous operation and does not have a published replacement interval; it runs until wear or noise signals the end of its service life.
What limits continuous running of this 24V .24A case fan?
The 24V 0.24A power rating and ball bearing design set the thermal and mechanical ceiling for sustained use.
How much noise and heat does this 80mm non-LED fan produce all day?
As a DC axial fan with ball bearing and no LED, it generates typical operational noise and minimal heat at 24V 0.24A.
Også i denne avdelingen
Kunder sammenlignet disse
Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.
