We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black 80mm square case fan 25mm thick with two wire connector

Zyvpee

Zyvpee CHA8024EBN-K(E) 8025 80*25mm 24V .24A 2 Pin case fan

SKU CH-WZXS-P9D17

An 80 mm square case fan with ball-bearing motor, 24 V .24 A draw and a two-pin power connector

  • TypeCase Fan
  • CompatibilityCase
  • Bearing TypeBall
  • Power Connector2 Pin
  • ColorBlack
  • LEDNon-LED
  • Ball-bearing design for long-lasting reliability
  • 24 V, 0.24 A draw suits industrial 24 V rails
  • Compact 80 × 25 mm frame fits tight chassis spaces
  • Two-pin connector enables simple voltage control
  • Non-LED black finish keeps builds clean and professional

Compact 80 mm case fan for 24 V systems

The Zyvpee CHA8024EBN-K(E) is an 80 by 25 mm DC axial fan built for computer cases that run on a 24 V supply. It draws 0.24 A through a two-pin connector and uses a ball bearing for continuous rotation. The black frame carries no lighting, making it suitable for industrial or server builds where illumination is not required.

Two-wire power cable simplifies wiring

The bundled two-pin lead plugs directly into a compatible 24 V header or terminal block, so no adapter or PWM controller is needed. Because the fan has no LED circuit, the cable carries only power and ground, reducing the chance of a misconnected signal wire. The ball bearing is lubricated for long life in always-on environments.

Straightforward screw mounting with polarity care

Four corner holes accept standard M3 screws for 80 mm fan positions, and the 25 mm thickness fits most slim chassis slots. Installers must verify that the supply is 24 V and observe the red and black wire polarity, as the two-pin plug has no keying. Reversing the wires will prevent the motor from starting.

Highlights

  • Ball-bearing design for long-lasting reliability
  • 24 V, 0.24 A draw suits industrial 24 V rails
  • Compact 80 × 25 mm frame fits tight chassis spaces
  • Two-pin connector enables simple voltage control
  • Non-LED black finish keeps builds clean and professional

Specifications

SeriesCHA8024EBN-K(E)
ModelCHA8024EBN-K(E)
TypeCase Fan
CompatibilityCase
Bearing TypeBall
Power Connector2 Pin
ColorBlack
LEDNon-LED
FeaturesDC axial fan
Dimensions80*80*25mm

Questions about this item

How often should the ball bearing in this 80*25mm fan be replaced?

The ball bearing is rated for continuous operation and does not have a published replacement interval; it runs until wear or noise signals the end of its service life.

What limits continuous running of this 24V .24A case fan?

The 24V 0.24A power rating and ball bearing design set the thermal and mechanical ceiling for sustained use.

How much noise and heat does this 80mm non-LED fan produce all day?

As a DC axial fan with ball bearing and no LED, it generates typical operational noise and minimal heat at 24V 0.24A.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.