NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Acceptăm criptomonede — astfel, criptomonedele pe care le dețineți pot cumpăra echipamente reale.Plătiți în cripto, cheltuiți-o pe echipamente reale. Livrare asigurată gratuită oriunde în lume peste 399 $. Cartoane neutre, fără marcă, expediate din Germania.Livrare asigurată gratuită peste 399 $. Cursul dumneavoastră este blocat timp de 30 de minute de la deschiderea paginii de plată.Curs blocat 30 de minute. Fiecare articol este sigilat, numărul de serie este verificat, iar produsul este acoperit de o garanție de 24 de luni.Sigilat, garantat 24 de luni.
KHACHIMO
An ATX power supply delivering 24 V at 2.2 A with 75 W output, 80 PLUS Gold efficiency, Modern Standby support, Zero RPM fan mode and resonant LLC topology with DC-to-DC conversion
This 75 W ATX unit delivers a fixed 24 V rail rated at 2.2 A and is designed as a direct replacement for the TDK-Lambda SWS75-24. It suits industrial PCs, embedded appliances and test rigs that require a single-voltage ATX-form-factor source with modern standby support.
Gold certification confirms high efficiency across the load range, reducing waste heat and fan demand. The resonant LLC topology with DC-to-DC conversion supplies clean power and minimises coil whine, while the zero-RPM fan mode stops the fan completely at low and medium loads for silent running.
High Gold-rated efficiency keeps internal temperatures modest during normal operation, allowing the fan to remain off for extended periods. When the fan does spin, it moves only the air needed for the actual load, so acoustic output and power consumption stay low in typical use.
| Type | ATX |
|---|
It is 80 PLUS Gold certified, so the supply runs at high efficiency, draws less power from the wall, produces less heat and keeps fan noise lower under typical loads.
The unit follows the standard ATX footprint, so it fits any case with an ATX power-supply bay and uses the usual four rear mounting screws.
Wire the 24 V rail to the matching 24 V input on your board or device, then verify the 2.2 A limit is not exceeded; the step most often missed is confirming the load stays within that 2.2 A rating before powering on.
Tot din acest raion
Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.
În ce monedă plătiți și în ce monedă citiți prețurile.
Trimis din portofelul dumneavoastră la finalizarea comenzii
Doar pentru afișare — catalogul este exprimat în dolari
Nicio monedă nu corespunde.
Alegeți limba în care vă vorbește site-ul.
Prima vizită?
Aveți deja un cont?
Nu există o resetare automată: acest magazin nu trimite niciun e-mail, deci nu există niciun link de unică folosință de solicitat. Lăsați adresa în cont. Va fi tratată manual.
Cerere înregistrată
Nu veți primi nimic în căsuța de e-mail — acest magazin nu trimite niciun e-mail. Cineva se ocupă de asta manual.
V-ați amintit-o?