Acceptăm criptomonede — astfel, criptomonedele pe care le dețineți pot cumpăra echipamente reale.Plătiți în cripto, cheltuiți-o pe echipamente reale. Livrare asigurată gratuită oriunde în lume peste 399 $. Cartoane neutre, fără marcă, expediate din Germania.Livrare asigurată gratuită peste 399 $. Cursul dumneavoastră este blocat timp de 30 de minute de la deschiderea paginii de plată.Curs blocat 30 de minute. Fiecare articol este sigilat, numărul de serie este verificat, iar produsul este acoperit de o garanție de 24 de luni.Sigilat, garantat 24 de luni.

Produse urmărite Conectare
Green circuit board with black memory chips, 260-pin SODIMM form factor

NEMIX RAM

NEMIX RAM 32GB DDR4 2933MHz PC4-23400 2Rx8 CL21 260-PIN SODIMM memory upgrade

SKU CH-X353-R6KKG

32 GB DDR4 SODIMM at 2933 MHz CL21 1.2 V 2Rx8 verified for Supermicro X12SCV motherboards

  • Capacity32GB
  • Type260-Pin DDR4 SODIMM
  • SpeedDDR4 2933 (PC4 23400)
  • CAS LatencyCL21
  • Voltage1.20V
  • ECCNo

Size 32GB

  • 32 GB capacity doubles memory headroom for demanding workloads
  • DDR4 2933 MHz speed matches the controller spec for full rated throughput
  • CL21 latency and 1.2 V voltage align with the platform's timing expectations
  • 2Rx8 rank on 260-pin SODIMM fits the Supermicro X12SCV-W and X12SCV-LVDS boards
  • Built with Samsung Micron or Hynix chips and tested for stability at rated settings

Exact-match upgrade for Supermicro systems

This 32 GB DDR4 SODIMM module runs at 2933 MHz with CL21 timing and 1.2 V operation. The 2Rx8 rank structure matches the memory controller expectations of the Supermicro X12SCV-W and X12SCV-LVDS motherboards. It installs as a single 260-pin unbuffered non-ECC stick for immediate capacity recognition.

Low-voltage operation keeps thermals simple

At 1.2 V the module draws minimal power and produces little heat without a heat spreader. Passive cooling inside a typical laptop or compact chassis is sufficient for sustained loads. The standard DDR4 voltage also avoids extra strain on the system's power delivery circuitry.

Fits the 260-pin SODIMM slot your board requires

The unbuffered form factor matches the physical and electrical specification of the target Supermicro platforms. No desktop UDIMM or registered DIMM will work in these sockets. Builders needing ECC support or higher densities per slot must look elsewhere because this kit provides a single non-ECC rank configuration.

Puncte forte

  • 32 GB capacity doubles memory headroom for demanding workloads
  • DDR4 2933 MHz speed matches the controller spec for full rated throughput
  • CL21 latency and 1.2 V voltage align with the platform's timing expectations
  • 2Rx8 rank on 260-pin SODIMM fits the Supermicro X12SCV-W and X12SCV-LVDS boards
  • Built with Samsung Micron or Hynix chips and tested for stability at rated settings

Specificații

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR4 Non-ECC Unbuffered SODIMM Memory
Part NumberMS23400-328K1
Capacity32GB
Type260-Pin DDR4 SODIMM
SpeedDDR4 2933 (PC4 23400)
CAS LatencyCL21
Voltage1.20V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR4 Non-ECC Unbuffered SODIMM Motherboard Compatible
Package Content32GB DDR4 2933MHz PC4-23400 2Rx8 1.2V 260-PIN Non-ECC SODIMM KIT

Alte versiuni ale acestui model

5 în plus din aceeași gamă

Aceeași familie, memorie, radiator sau frecvență diferite — comparați înainte de a vă decide.

Întrebări despre acest articol

How do I install the 260-pin SODIMM and what step is often missed?

Align the notch on the module with the slot key, insert at a slight angle, then press down until both side clips snap shut; the step often missed is fully seating both clips so the module sits flat and makes solid contact.

What maintenance or replacement will this DDR4 module need later?

No routine maintenance is required; if a chip fails the module is replaced under lifetime support, otherwise it remains in service for the system's usable life.

What limit appears first under sustained load with CL21 1.20 V DDR4-2933?

The CAS latency of 21 cycles at 1.20 V sets the timing ceiling; sustained workloads hit that latency bound before voltage or thermal limits become a factor.

Tot din acest raion

Clienții au comparat și acestea.

Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.