Acceptăm criptomonede — astfel, criptomonedele pe care le dețineți pot cumpăra echipamente reale.Plătiți în cripto, cheltuiți-o pe echipamente reale. Livrare asigurată gratuită oriunde în lume peste 399 $. Cartoane neutre, fără marcă, expediate din Germania.Livrare asigurată gratuită peste 399 $. Cursul dumneavoastră este blocat timp de 30 de minute de la deschiderea paginii de plată.Curs blocat 30 de minute. Fiecare articol este sigilat, numărul de serie este verificat, iar produsul este acoperit de o garanție de 24 de luni.Sigilat, garantat 24 de luni.

Produse urmărite Conectare
Four green DDR5 RDIMM modules without heat spreaders in a 256GB kit

NEMIX RAM

NEMIX RAM DDR5 6400 256GB 4x64GB CL52 1.1V 4Rx4 ECC Registered RDIMM memory upgrade

SKU CH-F37T-GNFG2

256 GB DDR5 registered ECC server memory kit, four 64 GB modules at 6400 MHz CL52 1.1 V, validated for Supermicro X14SDI-36C-SP3F

  • Capacity256GB (4 x 64GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 6400 (PC5 51200)
  • CAS LatencyCL52
  • Voltage1.10V
  • ECCYes

Size 256GB 4X64GB

  • 256 GB total capacity lets you fully populate four slots with 64 GB modules
  • DDR5 6400 speed with CL52 latency matches the motherboard's rated timing for stable operation
  • Registered ECC architecture offloads the controller and corrects single-bit errors to prevent data corruption
  • 1 V operating voltage meets the board's spec for efficient server memory performance
  • Verified compatible with the Supermicro X14SDI-36C-SP3F motherboard for exact-fit installation

Targeted Server Upgrade

This 256GB kit delivers four 64GB DDR5 6400 Registered ECC RDIMMs built to the exact rank, voltage and timing the Supermicro X14SDI-36C-SP3F memory controller expects. The 4Rx4 organisation and 1.1V operation let every slot run fully populated at rated speed without manual tuning.

Replaces Lower-Capacity Kits

Swapping a smaller or slower DDR5 kit for this 4x64GB set adds the full 256GB the board can address in a single validated configuration, eliminating the guesswork of mixing modules. The jump is worthwhile when workloads need the maximum registered capacity this platform supports.

DDR5 RDIMM Constraints

Registered DDR5 modules require a motherboard wired for 288-pin RDIMM signalling and a BIOS that recognises 4Rx4 density at PC5-51200 speeds. Systems limited to UDIMM, SODIMM or lower rank counts will not post with this kit installed.

Puncte forte

  • 256 GB total capacity lets you fully populate four slots with 64 GB modules
  • DDR5 6400 speed with CL52 latency matches the motherboard's rated timing for stable operation
  • Registered ECC architecture offloads the controller and corrects single-bit errors to prevent data corruption
  • 1 V operating voltage meets the board's spec for efficient server memory performance
  • Verified compatible with the Supermicro X14SDI-36C-SP3F motherboard for exact-fit installation

Specificații

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR51200-944K4
Capacity256GB (4 x 64GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 6400 (PC5 51200)
CAS LatencyCL52
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank4Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content256GB 4X64GB DDR5 6400MHz PC5-51200 4Rx4 1.1V 288-PIN ECC RDIMM KIT

Alte versiuni ale acestui model

5 în plus din aceeași gamă

Aceeași familie, memorie, radiator sau frecvență diferite — comparați înainte de a vă decide.

Întrebări despre acest articol

Will these 288-pin DDR5 RDIMMs physically fit the Supermicro X14SDI-36C-SP3F motherboard slots?

Yes, the kit uses the 288-pin RDIMM form factor that the X14SDI-36C-SP3F requires; it is not a UDIMM or SODIMM.

What is the correct installation order for the four 64 GB modules on this board?

Consult the Supermicro X14SDI-36C-SP3F manual for the approved DIMM population sequence; the board's memory-controller rules dictate which slots must be filled first.

Do the modules need any firmware updates or thermal-pad replacement during their service life?

No firmware updates or thermal-pad changes are required; the registered ECC design runs at 1.1 V without a heat spreader and is covered by a lifetime replacement warranty.

Tot din acest raion

Clienții au comparat și acestea.

Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.