NEMIX RAM
NEMIX RAM DDR5 6400 256GB (8x32GB) CL52 1.1V 2Rx8 ECC Registered RDIMM Supermicro H13SSW memory upgrade
256 GB DDR5-6400 registered ECC kit in eight 32 GB modules at CL52 and 1.1 V for the Supermicro H13SSW motherboard
- Capacity256GB (8 x 32GB)
- Type288-Pin DDR5 RDIMM
- SpeedDDR5 6400 (PC5 51200)
- CAS LatencyCL52
- Voltage1.10V
- ECCYes
- 256 GB capacity across eight 32 GB modules lets your Supermicro H13SSW handle large workloads
- DDR5 6400 speed with CL52 latency delivers rated throughput the memory controller expects
- 10 V registered ECC RDIMM architecture offloads the controller and corrects single-bit errors on the fly
- 2Rx8 dual-rank organisation enables full-capacity population in every slot without down-clocking
- 288-pin RDIMM form factor matches the board's exact slot and population requirements
Exact DDR5-6400 RDIMM kit for Supermicro H13SSW
This 256GB kit contains eight 32GB DDR5 6400 modules built to PC5-51200 speed with CL52 latency and 1.1V operation. Registered ECC architecture with 2Rx8 organisation provides the signal integrity and error correction required by server memory controllers. Modules use 288-pin RDIMM form factor and major OEM chips from Samsung, Micron or Hynix.
Verify motherboard manual for population rules
The Supermicro H13SSW requires Registered RDIMM modules, not UDIMM or SODIMM variants. Confirm the approved DIMM population order and maximum supported capacity per channel before ordering. Ensure the system BIOS is updated to a version that recognises fully populated DDR5-6400 Registered ECC configurations at rated speed.
Replaces partial or slower DDR5 RDIMM sets
Upgrading from a partially filled configuration or lower-speed DDR5 RDIMMs eliminates empty slots and raises bandwidth to the full PC5-51200 specification. The jump is worthwhile when workloads demand maximum registered ECC capacity and the board's memory controller supports eight 2Rx8 modules at 6400 MT/s without downclocking.
Puncte forte
- 256 GB capacity across eight 32 GB modules lets your Supermicro H13SSW handle large workloads
- DDR5 6400 speed with CL52 latency delivers rated throughput the memory controller expects
- 10 V registered ECC RDIMM architecture offloads the controller and corrects single-bit errors on the fly
- 2Rx8 dual-rank organisation enables full-capacity population in every slot without down-clocking
- 288-pin RDIMM form factor matches the board's exact slot and population requirements
Specificații
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM Original Series Server Memory |
| Model | DDR5 ECC RDIMM Registered Server Memory |
| Part Number | MR51200-328K8 |
| Capacity | 256GB (8 x 32GB) |
| Type | 288-Pin DDR5 RDIMM |
| Speed | DDR5 6400 (PC5 51200) |
| CAS Latency | CL52 |
| Voltage | 1.10V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx8 |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Heat Spreader | No |
| Compatible System | Supermicro |
| Features | DDR5 ECC RDIMM Motherboard Compatible |
| Package Content | 256GB 8X32GB DDR5 6400MHz PC5-51200 2Rx8 1.1V 288-PIN ECC RDIMM KIT |
Întrebări despre acest articol
Does the 256 GB kit ship as eight 32 GB modules or must I buy extra sticks?
The kit contains eight 32 GB DDR5 RDIMMs for a total of 256 GB; nothing else is required to reach that capacity.
Why choose the 256 GB 8×32 GB CL52 1.1 V version instead of a smaller kit?
This exact-match 256 GB kit uses 2Rx8 registered ECC modules at 1.1 V CL52, matching the Supermicro H13SSW population rules for full-speed operation.
Will the DDR5 6400 rating run at 6400 MT/s once installed in the H13SSW?
Yes, the modules are spec-matched to the board's memory controller so all eight slots operate at the rated DDR5 6400 speed when populated per the manual.
Tot din acest raion
Clienții au comparat și acestea.
Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.



