Solidigm
Solidigm SSDPF2KX038T1N1 D7-P5520 3.84 Tb enterprise SSD
3.84 Tb enterprise SSD with PCIe 4.0 x4 NVMe interface delivering up to 6700 Mbps read and 3600 Mbps write speeds in U.2 form factor
- 84 Tb capacity supports large-scale data workloads
- PCIe 4.0 x4 interface delivers up to 6700 MB/s read speeds
- NVMe protocol enables up to 3600 MB/s write throughput
- U.2 form factor fits standard 2.5-inch enterprise bays
- D7-P5520 series built for read-intensive server deployments
Solidigm D7-P5520 3.84 Tb enterprise SSD
The Solidigm D7-P5520 is a 3.84 Tb enterprise solid state drive built for data-centre workloads. It connects through a PCIe 4.0 x4 interface using Nvme protocol. Sequential reads reach up to 6700 Mbps and writes up to 3600 Mbps. The U.2 form factor fits hot-swap bays in rack servers.
Suits read-heavy server deployments.
This drive targets read-intensive applications such as content delivery, web hosting and analytics clusters where endurance and consistent latency matter. It is not designed for consumer desktop motherboards that lack U.2 backplanes or enterprise-grade power-loss protection. Buyers needing higher write endurance or a different capacity should evaluate other models in the same series.
Adds high-capacity flash to 2.5-inch hot-swap
The U.2 connector slots directly into existing 2.5-inch drive cages with PCIe 4.0 backplane wiring, freeing M.2 slots for other uses. It requires a server chassis and backplane that supply the PCIe 4.0 x4 link and sufficient cooling for sustained throughput. No extra adapters are needed when the platform already supports U.2 Nvme drives.
Puncte forte
- 84 Tb capacity supports large-scale data workloads
- PCIe 4.0 x4 interface delivers up to 6700 MB/s read speeds
- NVMe protocol enables up to 3600 MB/s write throughput
- U.2 form factor fits standard 2.5-inch enterprise bays
- D7-P5520 series built for read-intensive server deployments
Specificații
Nicio specificație publicată pentru acest articol deocamdată.
Întrebări despre acest articol
What connector does my server need for the U.2 form factor?
The drive fits a standard U.2 bay that carries a PCIe 4.0 x4 link.
Will the 6700 MB/s read speed work on a PCIe 3.0 backplane?
It will operate at PCIe 3.0 x4 speeds, so sequential reads will be lower than the 6700 MB/s ceiling.
How can I confirm the 3600 MB/s write figure after installation?
Run an NVMe benchmark such as fio with a sequential write job and compare the result to 3600 MB/s.
Tot din acest raion
Clienții au comparat și acestea.
Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.
