IBM
IBM ST9500620SS 500GB 7200RPM SAS 2.5in internal hard drive
A 500 GB SAS drive spinning at 7200 RPM in a 2.5 inch form factor, supplied new with a SYSTEM X tray
- 500 GB capacity stores large datasets
- 7200 RPM spindle delivers fast sequential access
- SAS 6 Gbps interface connects directly to servers
- 5 inch form factor fits dense drive bays
- Includes System X carrier tray for quick installation
500 GB 7200 RPM SAS hard drive
This 2.5 inch IBM drive delivers 500 GB of storage on a 6 Gbps SAS interface spinning at 7200 RPM. It ships new with a SYSTEM X carry tray included. The unit is built for internal server or storage array bays that accept SAS connections.
Suited for SAS-only bays and tray-mount servers
The drive fits 2.5 inch SAS hot-swap slots that use the supplied carry tray. It is not for systems that lack a SAS backplane or HBA, nor for laptops or desktops without SAS support. Buyers needing a different interface protocol or a higher capacity should consider other options.
6 Gbps SAS interface decides compatibility
The single specification that determines fit is the 6 Gbps SAS interface on a 2.5 inch form factor. Verify that your controller and backplane support this exact interface before purchase. The included tray matches SYSTEM X mounting points.
Poudarki
- 500 GB capacity stores large datasets
- 7200 RPM spindle delivers fast sequential access
- SAS 6 Gbps interface connects directly to servers
- 5 inch form factor fits dense drive bays
- Includes System X carrier tray for quick installation
Specifikacije
Za ta izdelek še ni objavljenih specifikacij.
Vprašanja o tem izdelku
What SAS controller or backplane do I need to run the ST9500620SS at 6Gbps?
A 6Gbps SAS HBA or RAID card with a 2.5in drive bay or backplane is required; the drive uses a standard SAS connector and will negotiate 6Gbps automatically.
Will the included SYSTEM X tray fit a non-IBM server that uses 2.5in SAS bays?
The tray follows the common 2.5in SAS form factor, so it fits most servers with tool-less 2.5in bays, but screw-hole alignment should be checked against the specific chassis.
How can I verify the ST9500620SS is running at 7200RPM and 6Gbps after installation?
Check the controller BIOS or OS utility — it should report 7200RPM spindle speed and a negotiated 6Gbps link rate for the drive.
Tudi v tem oddelku
Stranke so primerjale tudi te
Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.
Iomega Corp Z250ATAPI BLACK 250MB ZIP backup drive
- 250MB
- 2941RPM
DELL 7T0DW 600GB 2.5" SAS 10000 RPM laptop hard drive
- Serial Attached SCS…
- 10000 RPM
Seagate ST500LT015 500GB 5400 RPM 16MB Cache SATA 6.0Gb/s 2.5" 7mm laptop hard drive
- 500GB
- 5400 RPM



