Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.

Spremljani izdelki Prijava
Rectangular metal power supply unit with ventilation slots and label showing 30V 60W

KHACHIMO

KHACHIMO 30V 60W Switching Power Supply CFM60S300

SKU CH-Z8HA-3X0AZ

ATX switching power supply delivering 30 V at 60 W for compatible systems

  • TypeATX
  • Delivers stable 30 V output for sensitive circuits
  • 60 W capacity handles moderate loads reliably
  • ATX form factor fits standard chassis layouts
  • Tested working so it powers up immediately

30V 60W ATX Power Supply

This ATX switching power supply delivers 30 volts at 60 watts for systems that require a dedicated 30V rail. It is intended for builders or technicians replacing a CFM60S300 unit in compatible equipment. Each unit is tested and confirmed working before shipment.

Capacity and headroom

The 60 watt output handles loads that draw up to the full rated power on the 30 volt line. Headroom ends at that limit, so configurations demanding more than 60 watts or a different voltage rail cannot use this supply.

Poudarki

  • Delivers stable 30 V output for sensitive circuits
  • 60 W capacity handles moderate loads reliably
  • ATX form factor fits standard chassis layouts
  • Tested working so it powers up immediately

Specifikacije

TypeATX

Vprašanja o tem izdelku

Will the CFM60S300 fit in my older ATX case and power the original motherboard connectors?

Yes, the unit follows the ATX form factor so it mounts in standard ATX cases and provides the usual ATX power connectors for legacy motherboards.

How can I verify the 30 V output is stable after I install the CFM60S300?

Measure the 30 V rail with a multimeter under load; it should read close to 30 V and the supply is rated for 60 W continuous output.

Tudi v tem oddelku

Stranke so primerjale tudi te

Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.