Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.

Spremljani izdelki Prijava
KHACHIMO XL375-12 CS 375W 12V ATX power supply unit

KHACHIMO

KHACHIMO XL375-12 CS Power Supply 375W 12V

SKU CH-CQTX-XBBNZ

ATX power module delivering 375 W at 12 V with three-way output

  • TypeATX
  • Tested and confirmed working for reliable operation
  • 375 W output delivers stable power to demanding components
  • 12 V rail provides consistent voltage for critical hardware
  • ATX form factor fits standard chassis without modification

375 W ATX power module

This KHACHIMO XL375-12 CS is a 375 W ATX power supply built around a 12 V rail. It is intended for system integrators and repair technicians who need a tested, working replacement module for compatible platforms. The unit ships new and has been verified for basic operation before dispatch.

Direct replacement for the same form-factor unit

It serves as a like-for-like swap when the original 375 W 12 V module has failed or reached end of life. The jump is worth it when the existing supply shows instability under load or no longer powers the target hardware at all. No other capacity or voltage variant is addressed by this module.

Poudarki

  • Tested and confirmed working for reliable operation
  • 375 W output delivers stable power to demanding components
  • 12 V rail provides consistent voltage for critical hardware
  • ATX form factor fits standard chassis without modification

Specifikacije

TypeATX

Vprašanja o tem izdelku

What ATX mounting points does the 375 W unit use?

The power supply follows the standard ATX form factor, so it mounts with the four screw holes defined by the ATX specification.

Which cables must be connected first during installation?

Attach the 12 V main connector and the two auxiliary output leads to the motherboard and peripherals before switching the unit on.

Tudi v tem oddelku

Stranke so primerjale tudi te

Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.