Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.

Spremljani izdelki Prijava
A pair of black and red 10 AWG solar cables with MC4 connectors, 10 ft long

PFCTART

PFCTART 10 AWG 10FT Solar Extension Cable 6mm² MC4 Connectors

SKU CH-FF97-VP3SQ

10 ft 10 AWG solar extension cable with MC4 connectors rated for 600 V and 55 A to 70 A current

  • TypeSolar Panels
  • Solar Panel KitsOff-Grid
  • Kit AccessoriesWiring & Connector
  • Solar Cellsolar
  • Size/Dimensions10FT
  • Junction BoxIP67 rated
  • Safe short-circuit protection backed by IP67-rated junction box
  • High 55 A current capacity from 10 AWG 6 mm² copper conductors
  • UV oil salt and weather resistance proven to UL94-V0 flame class
  • Snap-in MC4 connectors fit panels inverters and DC circuits
  • Engineered for -40 °C to 85 °C operation with abrasion-resistant XLP insulation

10 AWG 10FT Solar Extension Cable

This 10 AWG extension cable spans ten feet with MC4 connectors on both ends. It carries up to 55 amps per conductor at 600 volts. The cross-linked polyethylene insulation operates from -40 °C to 85 °C and meets IP67 and UL94-V0 ratings for outdoor use.

Compatibility Check

Verify that your panels and charge controller use standard MC4 snap-in connectors. Confirm the system voltage does not exceed 600 volts DC and that 10 AWG gauge matches the current draw of your array. The cable pair includes one black and one red lead for polarity identification.

Upgrade Path

Replaces thinner or weather-damaged leads that limit current or degrade in sunlight. The jump is worth it when existing wiring cannot handle 55 amps or when insulation shows UV cracking. Not suited for runs requiring longer than ten feet or for permanent conduit installations needing armoured cable.

Poudarki

  • Safe short-circuit protection backed by IP67-rated junction box
  • High 55 A current capacity from 10 AWG 6 mm² copper conductors
  • UV oil salt and weather resistance proven to UL94-V0 flame class
  • Snap-in MC4 connectors fit panels inverters and DC circuits
  • Engineered for -40 °C to 85 °C operation with abrasion-resistant XLP insulation

Specifikacije

ModelSolar Panel Extension Cable Wire
Part NumberSolar Connectors
TypeSolar Panels
Solar Panel KitsOff-Grid
Kit AccessoriesWiring & Connector
Solar Cellsolar
Size/Dimensions10FT
Junction BoxIP67 rated
Output Cables6mm2
ConnectorsMC4 Connectors
NOCT Open Circuit Voltage (Voc)AC 600V/1000V, DC 1800V
Nominal Operating Cell Temperature (-40°C ~ 85°C
Selling UnitKit
Item CountIndoor/Outdoor
SpecificationsAcid Resistant, Chemical Resistant, Corrosion Resistant, Dust Resistant, Fade Resistant, Fingerprint Resistant, Fire Resistant, Flame Retardant, Gasoline/Oil Resistant, Grease Resistant, Heat Pressure Resistant, Heat Resistant, Moisture Resistant, Ozone Resistant, Sunlight/UV Resistant, Water Resistant, Weather Resistant
FeaturesAll Daylight Conditions, Corrosion Resistant, Flexible, Foldable, Portable
Sports TeamAgriculture/Farming, Aquaculture, Automotive, Back-up Power, Camping/Hiking, Commercial, Electronics, Home/Garden, Marine, Recreational Vehicle (RV)

Vprašanja o tem izdelku

What cables and connectors come in the kit and is anything else needed to use it?

The kit includes one black and one red 10 AWG 6 mm² solar extension cable, each 10 ft long with MC4 connectors already fitted. No extra parts are required for a standard panel-to-inverter run.

Should I choose the 55 A or 70 A current rating for my installation?

The cable is rated for 55 A continuous and 70 A peak per conductor; size your circuit protection and inverter input current to stay within the 55 A continuous figure for safe long-term operation.

What does the 600 V maximum voltage mean when the cable is connected to my array?

It means the cable insulation and MC4 connectors are tested to withstand up to 600 V DC, so the open-circuit voltage of your entire string must not exceed 600 V under the coldest expected temperature.

Tudi v tem oddelku

Stranke so primerjale tudi te

Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.