Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.

Spremljani izdelki Prijava
Silver 1U redundant server power supply module with rear handle and ventilation grille

WMtec

WMtec PWS-741P-1R 740W 1U 80 PLUS Platinum Redundant Server Power Supply

SKU CH-C89K-JZWJD

740 W 1U 80 PLUS Platinum redundant server supply with 100–240 V AC input and 12 V 61.7 A DC output

  • 740 W output for high-density server loads
  • 80 PLUS Platinum efficiency reduces energy waste and heat
  • 100–240 V AC input supports global rack deployments
  • Redundant hot-swap design keeps systems running during module replacement

WMtec PWS-741P-1R 740W Redundant Power Supply

This 1U server power supply delivers up to 740W from a single +12V rail rated at 61.7A with a +5Vsb auxiliary output of 4A. It operates on a wide AC input range of 100V to 240V at 50Hz to 60Hz and meets 80 PLUS Platinum efficiency standards. The redundant module design supports hot-swap replacement in compatible chassis.

Ideal for high-density rack servers

Suited for 1U rack servers requiring redundant, high-efficiency power with a 740W capacity and Platinum certification. Not intended for desktop ATX cases or builds needing multiple +12V rails, lower wattage units, or non-redundant form factors.

Poudarki

  • 740 W output for high-density server loads
  • 80 PLUS Platinum efficiency reduces energy waste and heat
  • 100–240 V AC input supports global rack deployments
  • Redundant hot-swap design keeps systems running during module replacement

Specifikacije

Za ta izdelek še ni objavljenih specifikacij.

Vprašanja o tem izdelku

What AC voltage range must my rack PDU provide for the PWS-741P-1R to operate?

The unit accepts 100 V to 240 V AC at 50 Hz or 60 Hz, drawing up to 10 A at the low end and 3.5 A at the high end.

Will the +5 V standby rail on this supply still power my legacy IPMI board that expects 4 A?

Yes, the +5 V standby output is rated at 4 A, matching the requirement of older management controllers.

Tudi v tem oddelku

Stranke so primerjale tudi te

Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.