NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Приемаме криптовалута — така монетите, които притежавате, могат да купят истински хардуер.Платете с крипто, похарчете го за истински хардуер. Безплатна застрахована доставка по целия свят над 399 $. Неутрални кашони без марка, изпратени от Германия.Безплатна застрахована доставка над 399 $. Курсът Ви е заключен за 30 минути веднага след отварянето на касата.Курс, заключен за 30 минути. Всеки артикул е запечатан, серийният му номер е проверен, и е покрит с 24-месечна гаранция.Запечатан, 24-месечна гаранция.
Brute Networks
8GB registered ECC DDR4 module running at 2933 MHz with 1.20 V operation for compatible HP servers
This module is an 8 GB DDR4-2933 Registered ECC DIMM built for HP servers. It uses major-brand DRAM chips and runs at 1.2 V. The part matches HP part number 5YZ56AT and is validated for 100 % compatibility with supported platforms.
The single specification that determines fit is the Registered 1Rx8 organisation running at PC4-23400. Unbuffered or differently ranked modules will not work in the same slots. Verify that your server requires Registered ECC memory with this exact rank and speed before ordering.
Installation follows the usual 288-pin DIMM procedure: align the key notch, press firmly until the latches click, and confirm seating. The most common issue is mixing modules of different rank or voltage, so the supplier ships identically matched sticks to prevent mismatched sets.
| Brand | HP |
|---|---|
| Capacity | 8GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2933 (PC4 23400) |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 1Rx8 |
| Chipset | Major Brand Chipset |
The module runs at 2933 MT/s when the server memory controller and BIOS are configured for that data rate. Actual throughput depends on the platform's supported speeds and the number of populated channels.
PC4-23400 identifies DDR4-2933 standard signalling at 1.2 V. The peak transfer rate is capped by the server's memory controller and the number of active channels.
It requires a standard 288-pin DDR4 RDIMM socket. The registered design adds a buffer chip, so the module fits only in server boards wired for registered memory.
Още от този рафт
Същият рафт, същата каса — осем монети и заключване на курса за 30 минути.
Това, което изпращате, и това, в което четете цените.
Изпратено от Вашия портфейл при поръчката
Само за визуализация — каталогът е в долари
Никоя валута не съответства.
Изберете езика, на който сайтът да Ви говори.
Нови сте тук?
Вече имате профил?
Няма автоматично нулиране: този магазин не изпраща имейли, така че няма еднократна връзка, която да поискате. Оставете адреса в профила си и той ще бъде обработен ръчно.
Заявката е приета
Нищо няма да пристигне във Вашата пощенска кутия — този магазин изобщо не изпраща имейли. Заявките се обработват ръчно.
Спомнихте си я?