NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
Brute Networks
8GB registered ECC DDR4 module running at 2933 MHz with 1.20 V operation for compatible HP servers
This module is an 8 GB DDR4-2933 Registered ECC DIMM built for HP servers. It uses major-brand DRAM chips and runs at 1.2 V. The part matches HP part number 5YZ56AT and is validated for 100 % compatibility with supported platforms.
The single specification that determines fit is the Registered 1Rx8 organisation running at PC4-23400. Unbuffered or differently ranked modules will not work in the same slots. Verify that your server requires Registered ECC memory with this exact rank and speed before ordering.
Installation follows the usual 288-pin DIMM procedure: align the key notch, press firmly until the latches click, and confirm seating. The most common issue is mixing modules of different rank or voltage, so the supplier ships identically matched sticks to prevent mismatched sets.
| Brand | HP |
|---|---|
| Capacity | 8GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2933 (PC4 23400) |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 1Rx8 |
| Chipset | Major Brand Chipset |
The module runs at 2933 MT/s when the server memory controller and BIOS are configured for that data rate. Actual throughput depends on the platform's supported speeds and the number of populated channels.
PC4-23400 identifies DDR4-2933 standard signalling at 1.2 V. The peak transfer rate is capped by the server's memory controller and the number of active channels.
It requires a standard 288-pin DDR4 RDIMM socket. The registered design adds a buffer chip, so the module fits only in server boards wired for registered memory.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?