Vi tager imod kryptovaluta — så den krypto, du ejer, kan købe rigtig hardware.Betal med krypto, brug det på rigtig hardware. Gratis, forsikret levering til hele verden ved køb over 399 $. Neutrale, umærkede papkasser, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Din kurs låses i 30 minutter, så snart kassen åbner.Kurs låst i 30 minutter. Hver vare er forseglet, har kontrolleret serienummer og er dækket af 24 måneders garanti.Forseglet, 24 måneders garanti.

Prisvagt Log ind
Green rectangular circuit board with gold edge connectors and black memory chips

A-Tech

A-Tech 8GB DDR4 2933 MHz ECC SODIMM 1Rx8 CL21 1.2V

SKU CH-EYFW-AQQM9

ECC SODIMM adds error correction to laptops, microservers and NAS units with 8 GB at 2933 MHz CL21

  • Capacity8GB
  • Type260-Pin DDR4 SO-DIMM
  • SpeedDDR4 2933 (PC4 23400)
  • CAS LatencyCL21
  • Voltage1.20V
  • ECCYes

Capacity 8GB

Speed DDR4 2933 (PC4 23400)

CAS Latency CL21

  • ECC protection guards data integrity in critical workloads
  • Unbuffered 260-pin DDR4 SODIMM fits compatible laptops and microservers
  • 2933 MHz speed with CL21 latency accelerates multitasking
  • 2 V JEDEC standard voltage reduces power draw
  • Single-rank 1Rx8 layout simplifies memory channel population

8GB DDR4 2933 ECC SODIMM for servers

This 260-pin module delivers 8 GB of DDR4 2933 memory with ECC protection for microservers, mobile workstations and NAS devices. The unbuffered design and single-rank x8 organisation suit systems that require error-correcting SO-DIMMs. It operates at the standard 1.2 V JEDEC voltage.

Thermals power and noise

As a solid-state memory module it generates minimal heat and produces no audible noise during normal operation. Power draw remains low at the rated 1.20 V, keeping thermal impact on the host system negligible. No active cooling is required.

ECC unbuffered SODIMM requirement

This part only works in platforms that explicitly support DDR4 ECC unbuffered SO-DIMM memory; standard consumer laptops without ECC capability will not accept it. Verify the system manual before purchase.

Fordele

  • ECC protection guards data integrity in critical workloads
  • Unbuffered 260-pin DDR4 SODIMM fits compatible laptops and microservers
  • 2933 MHz speed with CL21 latency accelerates multitasking
  • 2 V JEDEC standard voltage reduces power draw
  • Single-rank 1Rx8 layout simplifies memory channel population

Specifikationer

BrandA-Tech
SeriesA-Tech DDR4 ECC SODIMM
ModelA-Tech 8GB 1Rx8 PC4-23400 ECC SODIMM
Part NumberNE-SS-0573
Capacity8GB
Type260-Pin DDR4 SO-DIMM
SpeedDDR4 2933 (PC4 23400)
CAS LatencyCL21
Voltage1.20V
ECCYes
Buffered/RegisteredUnbuffered
Heat SpreaderNo
FeaturesECC SODIMM
Recommend UseAMD & Intel Compatible
OptionECC SODIMM

Andre versioner af denne model

5 flere i samme serie

Samme familie, men med anden hukommelse, køler eller clockfrekvens — sammenlign, før du bestemmer dig.

Spørgsmål om denne vare

How do I install the 260-pin DDR4 SODIMM and what step is often missed?

Align the notch on the module with the slot key, insert at an angle, then press firmly until both side clips snap into place; the step often missed is fully seating the module so the clips engage automatically.

What maintenance or replacement will this ECC SODIMM need over time?

No routine maintenance is required; the module has no heat spreader and runs at 1.20 V, so replacement is only necessary if a memory test reports correctable or uncorrectable ECC errors.

What limit appears first during sustained workloads on this CL21 2933 MHz module?

The CAS latency of 21 cycles at 2933 MHz sets the baseline access delay; under continuous heavy use the memory controller’s timing budget is reached before any thermal limit because the module operates at standard 1.20 V without a spreader.

Også på denne hylde

Kunderne har også sammenlignet disse

Samme hylde, samme kasse — otte mønter og 30 minutters kurslås.