DELL
DELL 400-AMPN 8TB 3.5" SAS 7.2K 12Gb/s internal hard drive
An 8 TB 3.5 inch SAS drive spinning at 7200 RPM with a 12 Gb/s transfer rate for high-capacity desktop storage
- PackagingBare Drive
- InterfaceSAS 12Gb/s
- Capacity8TB
- RPM7200 RPM
- Average Latency12Gb/s
- Form Factor3.5"
- 8TB capacity stores large datasets
- 7200 RPM spindle speed delivers fast sequential access
- SAS 12Gb/s interface provides high-throughput connectivity
- 5-inch form factor fits standard drive bays
- Non hot-swap design suits fixed internal installations
Dell 400-AMPN 8TB SAS enterprise drive
This 8TB 3.5" SAS hard drive operates at 7200 RPM with a 12Gb/s interface. It is a non hot-swap unit supplied as a bare drive for internal desktop or server installation. The Dell part number 400-AMPN identifies the exact component for procurement tracking.
Suits arrays needing high-capacity SAS spindles
Administrators expanding SAS-based RAID or JBOD volumes where drives remain fixed after installation will match this specification. Buyers whose chassis or backplane requires hot-swap trays cannot use this drive in those bays.
12Gb/s SAS interface and 7200 RPM spindle speed
The 12Gb/s SAS link and 7.2K rotation determine sustained throughput and latency for the target workload. Verify that the host controller and backplane support 12Gb/s SAS before purchase.
Fordele
- 8TB capacity stores large datasets
- 7200 RPM spindle speed delivers fast sequential access
- SAS 12Gb/s interface provides high-throughput connectivity
- 5-inch form factor fits standard drive bays
- Non hot-swap design suits fixed internal installations
Specifikationer
| Brand | Dell |
|---|---|
| Model | 400-AMPN |
| Packaging | Bare Drive |
| Interface | SAS 12Gb/s |
| Capacity | 8TB |
| RPM | 7200 RPM |
| Average Latency | 12Gb/s |
| Form Factor | 3.5" |
Spørgsmål om denne vare
What maximum throughput does the SAS 12Gb/s interface actually deliver with this 7200 RPM drive?
The 12Gb/s SAS link caps burst transfers at 12Gb/s, but sustained throughput is limited by the 7200 RPM mechanics, typically well below the interface ceiling.
Does the 3.5" non hot-swap form factor require a specific tray or caddy to mount in a Dell server bay?
Yes, the bare 3.5" drive must be secured in a compatible Dell 3.5" drive tray or caddy before it can be screwed into a server chassis bay.
How is the 400-AMPN installed in a non hot-swap bay, and which step is most often missed?
Power down the system, attach the drive to a Dell 3.5" tray, slide the assembly into the bay, connect both SAS data and power cables, then secure the tray screws — skipping the tray screws is the common error.
Også på denne hylde
Kunderne har også sammenlignet disse
Samme hylde, samme kasse — otte mønter og 30 minutters kurslås.
