KingSpec
KingSpec ACJC2M128S18 128GB 1.8-inch SATA internal SSD
A 1.8-inch SATA solid-state drive holding 128GB with MLC NAND, delivering read speeds up to 495MB/s and write speeds up to 191MB/s via a JMicron JMF608 controller
- Read speeds up to 495 MB/s for quick boot times
- Write speeds up to 191 MB/s for responsive file saves
- 128 GB capacity stores OS and essential apps
- 8-inch SATA form factor fits legacy laptops and industrial gear
- 1,000,000-hour MTBF and 0 °C to 70 °C rating for long service life
KingSpec 128 GB 1.8-inch SATA SSD
This KingSpec ACJC2M128S18 is a 128 GB internal solid-state drive built in the 1.8-inch form factor with a SATA III interface. It uses a JMicron JMF608 controller and MLC NAND flash to deliver sequential reads up to 495 MB/s and writes up to 191 MB/s. The drive is suited to any Windows or Mac system that provides a standard SATA connection.
Suits older laptops and embedded systems needing
The 1.8-inch size and SATA III interface make this drive a direct fit for legacy notebooks, industrial PCs or compact appliances that only accept this physical format. Buyers whose hardware requires a 2.5-inch drive, an M.2 module or a higher capacity than 128 GB will need a different part.
1.8-inch form factor decides compatibility
The single specification that determines whether this SSD works is its 1.8-inch physical size combined with the SATA III connector. If the target device does not have a matching 1.8-inch SATA bay, the drive cannot be installed regardless of its performance figures.
Fordele
- Read speeds up to 495 MB/s for quick boot times
- Write speeds up to 191 MB/s for responsive file saves
- 128 GB capacity stores OS and essential apps
- 8-inch SATA form factor fits legacy laptops and industrial gear
- 1,000,000-hour MTBF and 0 °C to 70 °C rating for long service life
Specifikationer
Der er endnu ikke offentliggjort specifikationer for denne vare.
Spørgsmål om denne vare
What do I need in my system for this 1.8-inch SATA III drive to work?
Any Windows or Mac system with a SATA interface will accept the 128GB ACJC2M128S18; the JMicron JMF608 controller and MLC NAND Flash handle the rest.
Can I keep using an older SATA II controller with this SSD?
The drive runs on SATA III at up to 495MB/sec read and 191MB/sec write, and will negotiate down to SATA II speeds if the host controller only supports that standard.
How can I verify the ACJC2M128S18 is healthy after installation?
Enable SMART monitoring in your OS or BIOS; the drive reports temperature (0°C–70°C range), media wear and other health attributes through the standard SMART interface.
Også på denne hylde
Kunderne har også sammenlignet disse
Samme hylde, samme kasse — otte mønter og 30 minutters kurslås.
