BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Vi tager imod kryptovaluta — så den krypto, du ejer, kan købe rigtig hardware.Betal med krypto, brug det på rigtig hardware. Gratis, forsikret levering til hele verden ved køb over 399 $. Neutrale, umærkede papkasser, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Din kurs låses i 30 minutter, så snart kassen åbner.Kurs låst i 30 minutter. Hver vare er forseglet, har kontrolleret serienummer og er dækket af 24 måneders garanti.Forseglet, 24 måneders garanti.
OWC
8GB DDR4 2400MHz CL17 SODIMM upgrades Dell Inspiron 15 3515, 3583, 3584, 3585 and 5570 laptops
This 8GB DDR4 SODIMM is validated for Dell Inspiron 15 3515, 3583, 3584, 3585 and 5570 laptops. It targets owners of those specific machines who want a straightforward memory increase without compatibility guesswork. The module follows the exact 260-pin layout and voltage profile those systems expect.
Operating at 1.2V with CL17 latency at 2400MHz, the stick runs within standard JEDEC limits for DDR4 SODIMMs. No heat spreader is fitted, so the module relies on the laptop's existing airflow and low-power DDR4 characteristics. Typical power draw stays at the nominal 1.2V level defined by the specification.
OWC backs the module with a limited lifetime warranty and free technical support from their engineering team. An advanced replacement programme is offered, so a verified faulty unit can be swapped before the original is returned. Compliance with JEDEC and RoHS standards keeps the upgrade warranty-safe for the host laptop.
| Brand | OWC |
|---|---|
| Part Number | 2S4D41R808GB |
| Capacity | 8GB |
| Type | 260-Pin DDR4 Non-ECC SODIMM |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Voltage | 1.2V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 1Rx8 |
| Heat Spreader | No |
| Compatible System | Dell Inspiron 15 3515 Dell Inspiron 15 3583 Dell Inspiron 15 3584 Dell Inspiron 15 3585 Dell Inspiron 15 5570 |
Power off the laptop, remove the battery if accessible, open the memory compartment, align the notch on the module with the slot key, insert at an angle then press down until the side clips click; the step often missed is verifying the clips have fully locked on both sides.
No routine maintenance is required; the module is a non-ECC unbuffered SODIMM without a heat spreader, so replacement is only needed if a memory error appears or you upgrade to a higher capacity kit.
The CL17 latency at DDR4 2400 speed sets the throughput ceiling; under continuous load the memory controller will hit that timing limit before voltage or thermal constraints become a factor.
Også på denne hylde
Samme hylde, samme kasse — otte mønter og 30 minutters kurslås.
Det du betaler med, og det du ser priserne i.
Sendes fra din tegnebog i kassen
Kun til visning — kataloget er prissat i USD
Ingen valuta matcher det.
Vælg det sprog, siden taler til dig på.
Ingen sprog matcher.
Ny her?
Har du allerede en?
Der findes ingen automatisk nulstilling: denne butik sender ingen e-mails, så der er intet engangslink at bede om. Efterlad adressen på kontoen, så bliver den behandlet manuelt.
Anmodning registreret
Der er intet på vej til din indbakke — denne butik sender slet ingen e-mails. Nogen behandler dem manuelt.
Kom du i tanke om den?