BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Vi tar emot kryptovaluta — så att kryptot du äger kan köpa riktig hårdvara.Betala med krypto, använd det till riktig hårdvara. Fri, försäkrad frakt över hela världen vid köp över 399 $. Neutrala, omärkta ytterkartonger, skickade från Tyskland.Fri, försäkrad frakt över 399 $. Din kurs låses i 30 minuter så snart kassan öppnas.Kursen låst i 30 minuter. Varje artikel är förseglad, har kontrollerat serienummer och täcks av 24 månaders garanti.Förseglad, 24 månaders garanti.
OWC
8GB DDR4 2400MHz CL17 SODIMM upgrades Dell Inspiron 15 3515, 3583, 3584, 3585 and 5570 laptops
This 8GB DDR4 SODIMM is validated for Dell Inspiron 15 3515, 3583, 3584, 3585 and 5570 laptops. It targets owners of those specific machines who want a straightforward memory increase without compatibility guesswork. The module follows the exact 260-pin layout and voltage profile those systems expect.
Operating at 1.2V with CL17 latency at 2400MHz, the stick runs within standard JEDEC limits for DDR4 SODIMMs. No heat spreader is fitted, so the module relies on the laptop's existing airflow and low-power DDR4 characteristics. Typical power draw stays at the nominal 1.2V level defined by the specification.
OWC backs the module with a limited lifetime warranty and free technical support from their engineering team. An advanced replacement programme is offered, so a verified faulty unit can be swapped before the original is returned. Compliance with JEDEC and RoHS standards keeps the upgrade warranty-safe for the host laptop.
| Brand | OWC |
|---|---|
| Part Number | 2S4D41R808GB |
| Capacity | 8GB |
| Type | 260-Pin DDR4 Non-ECC SODIMM |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Voltage | 1.2V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 1Rx8 |
| Heat Spreader | No |
| Compatible System | Dell Inspiron 15 3515 Dell Inspiron 15 3583 Dell Inspiron 15 3584 Dell Inspiron 15 3585 Dell Inspiron 15 5570 |
Power off the laptop, remove the battery if accessible, open the memory compartment, align the notch on the module with the slot key, insert at an angle then press down until the side clips click; the step often missed is verifying the clips have fully locked on both sides.
No routine maintenance is required; the module is a non-ECC unbuffered SODIMM without a heat spreader, so replacement is only needed if a memory error appears or you upgrade to a higher capacity kit.
The CL17 latency at DDR4 2400 speed sets the throughput ceiling; under continuous load the memory controller will hit that timing limit before voltage or thermal constraints become a factor.
Även i den här avdelningen
Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.
Det du betalar med, och det du ser priserna i.
Skickas från din plånbok i kassan
Endast visning — katalogen är prissatt i US-dollar
Ingen valuta matchar.
Välj det språk du vill att webbplatsen ska visas på.
Inga språk matchar.
Ny här?
Har du redan ett konto?
Det finns ingen automatisk återställning: den här butiken skickar inga e-postmeddelanden, så det finns ingen engångslänk att begära. Lämna adressen kopplad till kontot, så hanteras den för hand.
Förfrågan noterad
Inget är på väg till din inkorg — den här butiken skickar aldrig e-post. Någon tar hand om detta manuellt.
Kom du på det?