Two green DDR3 ECC RDIMM modules with gold contacts on black circuit boards

A-Tech

A-Tech 8GB Kit (2x4GB) DDR3 1333MHz ECC RDIMM 240-Pin Memory Upgrade

SKU CH-8VVQ-NBMGJ

An 8 GB DDR3 ECC registered memory kit for Mac Pro models from 2010 and 2012

Capacity8GB (2 x 4GB)
SpeedDDR3 1333 (PC3 10600)
Voltage1.50V
ECCYes
Buffered/RegisteredRegistered
ChipsetMajor Brand Chipset

8GB DDR3 kit boosts Mac Pro multitasking capacity
1333MHz ECC registered modules protect data integrity
Dual 4GB RDIMMs fit 240-pin Mac Pro slots
Tested for Apple Mac Pro 2010 and 2012 models
Major-brand chips validated through rigorous quality testing

47,99 $

0.00061653 BTC με τη σημερινή ισοτιμία

Διαθέσιμο · αποστολή σήμερα

Το ταμείο κλειδώνει την ισοτιμία σας για 30 λεπτά.

Παράδοση προς Ηνωμένες Πολιτείες εκτίμηση

UPS Worldwide Expedited 3–6 εργάσιμες ημέρες 39,90 $
DHL Express Worldwide 2–3 εργάσιμες ημέρες 74,90 $

Προσθέστε 351,01 $ ακόμη και η βασική αποστολή γίνεται δωρεάν.

Οι εισαγωγικοί δασμοί επιβάλλονται κατά την άφιξη από τη χώρα σας.

Αποστολή αλλού

Designed for Mac Pro Tower

This 8GB kit contains two 4GB DDR3 1333MHz ECC registered DIMMs built for Apple Mac Pro systems from Mid 2010 and Mid 2012 with 6-core or 12-core Xeon processors. It matches the MD771LL/A order number and MacPro5,1 model identifier for direct compatibility.

Thermals noise and power

Operating at a standard 1.50V, these registered modules draw typical DDR3 power without additional cooling requirements. The ECC registered design adds minimal electrical load while maintaining signal integrity across the memory bus during sustained workloads.

ECC registered DDR3

The kit provides 2Rx4 ECC registered DDR3 memory at PC3-10600 speed, a requirement for the target Mac Pro models to boot and run stably. Systems needing unbuffered non-ECC UDIMMs or a different DDR generation cannot use this memory.

Βασικά χαρακτηριστικά

8GB DDR3 kit boosts Mac Pro multitasking capacity
1333MHz ECC registered modules protect data integrity
Dual 4GB RDIMMs fit 240-pin Mac Pro slots
Tested for Apple Mac Pro 2010 and 2012 models
Major-brand chips validated through rigorous quality testing

Προδιαγραφές

Brand	A-Tech
Series	A-Tech DDR3 Apple Mac RAM Memory Upgrades
Capacity	8GB (2 x 4GB)
Speed	DDR3 1333 (PC3 10600)
Voltage	1.50V
ECC	Yes
Buffered/Registered	Registered
Chipset	Major Brand Chipset
Compatible System	Apple Mac Systems
Features	Major Brand Chips

Ερωτήσεις για αυτό το προϊόν

How do I install the 240-pin RDIMM modules in the Mac Pro and what slot order should I follow?

Power down the Mac Pro, open the side panel, and insert each 4 GB DDR3 1333 MHz module into the DIMM slots in matching pairs starting with the lowest-numbered slots for each CPU tray; the registered ECC design requires firm, even pressure until the latches click.

Will the ECC registered DIMMs need any firmware updates or periodic re-seating over time?

No firmware updates are required for the DDR3 1333 MHz ECC RDIMM kit; the modules are tested for lifetime reliability and only need re-seating if the system reports memory errors after a major hardware change.

At what workload level does the 1.50 V DDR3 1333 MHz speed become the bottleneck?

Sustained memory-intensive tasks that exceed the 1333 MT/s transfer rate — such as large dataset processing or heavy virtualization — will hit the DDR3 1333 MHz bandwidth ceiling before the registered ECC logic or voltage limit.

Επίσης σε αυτό το ράφι