NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.
A-Tech
An 8 GB DDR3 ECC registered memory kit for Mac Pro models from 2010 and 2012
This 8GB kit contains two 4GB DDR3 1333MHz ECC registered DIMMs built for Apple Mac Pro systems from Mid 2010 and Mid 2012 with 6-core or 12-core Xeon processors. It matches the MD771LL/A order number and MacPro5,1 model identifier for direct compatibility.
Operating at a standard 1.50V, these registered modules draw typical DDR3 power without additional cooling requirements. The ECC registered design adds minimal electrical load while maintaining signal integrity across the memory bus during sustained workloads.
The kit provides 2Rx4 ECC registered DDR3 memory at PC3-10600 speed, a requirement for the target Mac Pro models to boot and run stably. Systems needing unbuffered non-ECC UDIMMs or a different DDR generation cannot use this memory.
| Brand | A-Tech |
|---|---|
| Series | A-Tech DDR3 Apple Mac RAM Memory Upgrades |
| Capacity | 8GB (2 x 4GB) |
| Speed | DDR3 1333 (PC3 10600) |
| Voltage | 1.50V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Chipset | Major Brand Chipset |
| Compatible System | Apple Mac Systems |
| Features | Major Brand Chips |
Power down the Mac Pro, open the side panel, and insert each 4 GB DDR3 1333 MHz module into the DIMM slots in matching pairs starting with the lowest-numbered slots for each CPU tray; the registered ECC design requires firm, even pressure until the latches click.
No firmware updates are required for the DDR3 1333 MHz ECC RDIMM kit; the modules are tested for lifetime reliability and only need re-seating if the system reports memory errors after a major hardware change.
Sustained memory-intensive tasks that exceed the 1333 MT/s transfer rate — such as large dataset processing or heavy virtualization — will hit the DDR3 1333 MHz bandwidth ceiling before the registered ECC logic or voltage limit.
Aj v tomto oddelení
Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.
Mena, v ktorej platíte, a mena, v ktorej sa zobrazujú ceny.
Odoslané z vašej peňaženky na pokladni
Len na zobrazenie — katalóg je uvedený v dolároch
Žiadna mena nezodpovedá.
Vyberte jazyk, v ktorom s vami bude web komunikovať.
Ste tu prvýkrát?
Účet už máte?
Automatický reset hesla neexistuje: tento obchod neposiela žiadne e-maily, takže neexistuje jednorazový odkaz, o ktorý by ste mohli požiadať. Nechajte adresu na účte — niekto sa jej ujme ručne.
Žiadosť zaznamenaná
Do vašej schránky nič nepríde — tento obchod neposiela vôbec žiadne e-maily. Niekto sa o to postará ručne.
Spomenuli ste si?