NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Wij accepteren cryptovaluta — zo kunnen de munten die u bezit echte hardware kopen.Betaal in crypto, besteed het aan echte hardware. Gratis verzekerde verzending wereldwijd vanaf $399. Neutrale dozen zonder merk, verzonden vanuit Duitsland.Gratis verzekerde verzending vanaf $399. Uw koers wordt 30 minuten vastgezet zodra het afrekenen begint.Koers 30 minuten vastgezet. Elk artikel is verzegeld, het serienummer wordt gecontroleerd, en het valt onder 24 maanden garantie.Verzegeld, 24 maanden garantie.
A-Tech
An 8 GB DDR3 ECC registered memory kit for Mac Pro models from 2010 and 2012
This 8GB kit contains two 4GB DDR3 1333MHz ECC registered DIMMs built for Apple Mac Pro systems from Mid 2010 and Mid 2012 with 6-core or 12-core Xeon processors. It matches the MD771LL/A order number and MacPro5,1 model identifier for direct compatibility.
Operating at a standard 1.50V, these registered modules draw typical DDR3 power without additional cooling requirements. The ECC registered design adds minimal electrical load while maintaining signal integrity across the memory bus during sustained workloads.
The kit provides 2Rx4 ECC registered DDR3 memory at PC3-10600 speed, a requirement for the target Mac Pro models to boot and run stably. Systems needing unbuffered non-ECC UDIMMs or a different DDR generation cannot use this memory.
| Brand | A-Tech |
|---|---|
| Series | A-Tech DDR3 Apple Mac RAM Memory Upgrades |
| Capacity | 8GB (2 x 4GB) |
| Speed | DDR3 1333 (PC3 10600) |
| Voltage | 1.50V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Chipset | Major Brand Chipset |
| Compatible System | Apple Mac Systems |
| Features | Major Brand Chips |
Power down the Mac Pro, open the side panel, and insert each 4 GB DDR3 1333 MHz module into the DIMM slots in matching pairs starting with the lowest-numbered slots for each CPU tray; the registered ECC design requires firm, even pressure until the latches click.
No firmware updates are required for the DDR3 1333 MHz ECC RDIMM kit; the modules are tested for lifetime reliability and only need re-seating if the system reports memory errors after a major hardware change.
Sustained memory-intensive tasks that exceed the 1333 MT/s transfer rate — such as large dataset processing or heavy virtualization — will hit the DDR3 1333 MHz bandwidth ceiling before the registered ECC logic or voltage limit.
Ook in deze afdeling
Dezelfde afdeling, dezelfde kassa — acht munten en een koers die 30 minuten vaststaat.
Waarmee u betaalt, en waarin u de prijzen leest.
Verzonden vanuit uw wallet bij het afrekenen
Alleen ter weergave — de catalogus is geprijsd in USD
Geen valuta gevonden.
Kies de taal waarin de site met u spreekt.
Nieuw hier?
Al een account?
Er is geen automatisch herstel: deze winkel verstuurt geen e-mail, dus er is geen eenmalige link om aan te vragen. Laat het adres op het account achter en het wordt handmatig opgepakt.
Verzoek genoteerd
Er is niets onderweg naar uw inbox — deze winkel verstuurt helemaal geen e-mail. Iemand pakt dit handmatig op.
Weet u het weer?