EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.
A-Tech
An 8 GB DDR3 ECC registered memory kit for Mac Pro models from 2010 and 2012
This 8GB kit contains two 4GB DDR3 1333MHz ECC registered DIMMs built for Apple Mac Pro systems from Mid 2010 and Mid 2012 with 6-core or 12-core Xeon processors. It matches the MD771LL/A order number and MacPro5,1 model identifier for direct compatibility.
Operating at a standard 1.50V, these registered modules draw typical DDR3 power without additional cooling requirements. The ECC registered design adds minimal electrical load while maintaining signal integrity across the memory bus during sustained workloads.
The kit provides 2Rx4 ECC registered DDR3 memory at PC3-10600 speed, a requirement for the target Mac Pro models to boot and run stably. Systems needing unbuffered non-ECC UDIMMs or a different DDR generation cannot use this memory.
| Brand | A-Tech |
|---|---|
| Series | A-Tech DDR3 Apple Mac RAM Memory Upgrades |
| Capacity | 8GB (2 x 4GB) |
| Speed | DDR3 1333 (PC3 10600) |
| Voltage | 1.50V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Chipset | Major Brand Chipset |
| Compatible System | Apple Mac Systems |
| Features | Major Brand Chips |
Power down the Mac Pro, open the side panel, and insert each 4 GB DDR3 1333 MHz module into the DIMM slots in matching pairs starting with the lowest-numbered slots for each CPU tray; the registered ECC design requires firm, even pressure until the latches click.
No firmware updates are required for the DDR3 1333 MHz ECC RDIMM kit; the modules are tested for lifetime reliability and only need re-seating if the system reports memory errors after a major hardware change.
Sustained memory-intensive tasks that exceed the 1333 MT/s transfer rate — such as large dataset processing or heavy virtualization — will hit the DDR3 1333 MHz bandwidth ceiling before the registered ECC logic or voltage limit.
Einnig í þessum vöruflokki
Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.
Það sem þú greiðir í, og það sem þú sérð verð í.
Sent úr veskinu þínu í greiðsluferlinu
Aðeins til skýringar — verð í vörulistanum eru í Bandaríkjadölum
Enginn gjaldmiðill passar við það.
Veldu tungumálið sem síðan talar við þig á.
Fyrsta heimsókn?
Áttu þegar aðgang?
Það er engin sjálfvirk endurstilling: þessi verslun sendir engan tölvupóst, svo það er enginn einnota tengill til að biðja um. Skildu netfangið eftir á aðganginum og einhver sinnir því handvirkt.
Beiðni skráð
Ekkert er á leiðinni í pósthólfið þitt — þessi verslun sendir engan tölvupóst. Einhver sinnir þessu handvirkt.
Mundir þú það?