NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Acceptăm criptomonede — astfel, criptomonedele pe care le dețineți pot cumpăra echipamente reale.Plătiți în cripto, cheltuiți-o pe echipamente reale. Livrare asigurată gratuită oriunde în lume peste 399 $. Cartoane neutre, fără marcă, expediate din Germania.Livrare asigurată gratuită peste 399 $. Cursul dumneavoastră este blocat timp de 30 de minute de la deschiderea paginii de plată.Curs blocat 30 de minute. Fiecare articol este sigilat, numărul de serie este verificat, iar produsul este acoperit de o garanție de 24 de luni.Sigilat, garantat 24 de luni.
A-Tech
An 8 GB DDR3 ECC registered memory kit for Mac Pro models from 2010 and 2012
This 8GB kit contains two 4GB DDR3 1333MHz ECC registered DIMMs built for Apple Mac Pro systems from Mid 2010 and Mid 2012 with 6-core or 12-core Xeon processors. It matches the MD771LL/A order number and MacPro5,1 model identifier for direct compatibility.
Operating at a standard 1.50V, these registered modules draw typical DDR3 power without additional cooling requirements. The ECC registered design adds minimal electrical load while maintaining signal integrity across the memory bus during sustained workloads.
The kit provides 2Rx4 ECC registered DDR3 memory at PC3-10600 speed, a requirement for the target Mac Pro models to boot and run stably. Systems needing unbuffered non-ECC UDIMMs or a different DDR generation cannot use this memory.
| Brand | A-Tech |
|---|---|
| Series | A-Tech DDR3 Apple Mac RAM Memory Upgrades |
| Capacity | 8GB (2 x 4GB) |
| Speed | DDR3 1333 (PC3 10600) |
| Voltage | 1.50V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Chipset | Major Brand Chipset |
| Compatible System | Apple Mac Systems |
| Features | Major Brand Chips |
Power down the Mac Pro, open the side panel, and insert each 4 GB DDR3 1333 MHz module into the DIMM slots in matching pairs starting with the lowest-numbered slots for each CPU tray; the registered ECC design requires firm, even pressure until the latches click.
No firmware updates are required for the DDR3 1333 MHz ECC RDIMM kit; the modules are tested for lifetime reliability and only need re-seating if the system reports memory errors after a major hardware change.
Sustained memory-intensive tasks that exceed the 1333 MT/s transfer rate — such as large dataset processing or heavy virtualization — will hit the DDR3 1333 MHz bandwidth ceiling before the registered ECC logic or voltage limit.
Tot din acest raion
Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.
În ce monedă plătiți și în ce monedă citiți prețurile.
Trimis din portofelul dumneavoastră la finalizarea comenzii
Doar pentru afișare — catalogul este exprimat în dolari
Nicio monedă nu corespunde.
Alegeți limba în care vă vorbește site-ul.
Prima vizită?
Aveți deja un cont?
Nu există o resetare automată: acest magazin nu trimite niciun e-mail, deci nu există niciun link de unică folosință de solicitat. Lăsați adresa în cont. Va fi tratată manual.
Cerere înregistrată
Nu veți primi nimic în căsuța de e-mail — acest magazin nu trimite niciun e-mail. Cineva se ocupă de asta manual.
V-ați amintit-o?